This specification covers procedures for obtaining first-article (preproduction) approval of forgings and the controls to be exercised in producing subsequent production forgings.
The purpose of this specification is to establish requirements of a grinding method and to provide grinding parameters that will eliminate or minimize overheating, cracking, high residual tensile stresses, and/or other metallurgical changes that decrease structural integrity of steel parts or chrome plated steel parts (see 8.3). This standard establishes requirements for low stress grinding of martensitic high strength steel heat-treated to 180 ksi (1241 MPa) minimum ultimate tensile strength (UTS) and above, and requirements for low stress grinding of chromium plating applied to such high strength steel.
This specification covers established inch/pound manufacturing tolerances applicable to low-alloy steel sheet, strip, and plate ordered to inch/pound dimensions. These tolerances apply to all conditions unless otherwise noted. The term “excl” is used to apply only to the higher figure of the specified range.
This specification, in conjunction with the general requirements for steel heat treatment covered in AMS2759, establishes the requirements for heat treatment of low-alloy steel parts to minimum ultimate tensile strengths of 220 ksi (1517 MPa) and higher. Parts are defined in AMS2759. The requirements for heat treatment of alloy Aermet100 are no longer part of this specification and can be found in AMS2759/3. Due to the limited hardenability of these materials, size limits have been added to this specification.
This practice provides a method for evaluating microhardness and microstructure very close (0.002 inch (0.051 mm) or less) to the surface of a disk specimen. Specific accept/reject criteria for partial decarburization (3.7.1), inadvertent carburization/nitriding (3.7.3), total decarburization/intergranular oxidation (3.8), and other characteristics evaluated are to be found in the applicable specification where this ARP is referenced.
The purpose of this specification is to establish requirements of a grinding method and to provide grinding parameters that will eliminate or minimize overheating, cracking, high residual tensile stresses, and/or other metallurgical changes that decrease structural integrity of steel parts or chrome plated steel parts (See 8.2). This standard establishes requirements for low stress grinding of martensitic high strength steel heat-treated to 180 ksi (1241 MPa) minimum ultimate tensile strength (UTS) and above, and requirements for low stress grinding of chromium plating applied to such high strength steel.
This specification covers steel cleanliness requirements in inch/pound units for special aircraft-quality ferromagnetic steels, including hardenable corrosion resistant steels, by magnetic particle inspection methods. This specification contains sampling, sample preparation, inspection procedures and cleanliness rating criteria (see 8.2).
This specification covers steel cleanliness requirements in inch/pound units for premium aircraft-quality ferromagnetic steels, including hardenable, corrosion-resistant steels, by magnetic particle inspection methods. This specification contains sampling, sample preparation, inspection procedures and cleanliness rating criteria (see 8.2).
This specification covers steel cleanliness requirements in inch/pound units for aircraft-quality ferro-magnetic steels, other than hardenable corrosion resistant steels (refer to AMS2303), by magnetic particle inspection methods. This specification contains sampling, specimen preparation, inspection procedures and cleanliness rating criteria (see 8.5).
This specification, in conjunction with the general requirements for steel heat treatment covered in AMS2759, establishes the requirements for heat treatment of low-alloy steel parts to minimum ultimate tensile strengths of 220 ksi (1517 MPa) and higher. Parts are defined in AMS2759. The requirements for heat treatment of alloy Aermet100 are no longer part of this specification and can be found in AMS2759/3. Due to the limited hardenability of these materials, size limits have been added to this specification.
This specification covers established inch/pound manufacturing tolerances applicable to carbon steel bars ordered to inch/pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term “excl” applies only to the higher figure of the specified range.