Refine Your Search

Date

Date

Topic

Topic

Combustion and combustion processes Research and development On-board energy sources Design Engineering and Styling Simulation and modeling Medical, health, and wellness E-25 General Standards for Aerospace and Propulsion Systems Finite element analysis

Search Results

Viewing 1 to 20 of 60
123Next >Last >>
Sort by published
Standard

Lubricant, Solid Film
2022-04-01
CURRENT
AS1701F
This document covers the performance requirements for solid dry film lubricants, air dried or heat cured, for use in aerospace applications. These lubricants are intended to prevent galling, and may be capable of remaining effective for extended periods of time after exposure to extreme environmental conditions.
Standard

Thread Inspection Practices
2020-02-03
CURRENT
AS5870
This document addresses AS8879 thread inspection issues relating to selection, usage and capability of gages. It addresses the selection of calibrated measurement gages, the need for defined quality metrics, the methodology of determining the appropriate guardband factors, and the minimum inspection requirements for single element pitch diameter gages. Users of this document shall apply the information described herein for the evaluation of the capability of their measurements based on the measurement consumer risk. It involves the analysis of the measurement (product) distribution and biases of both the product and measurement system distributions. It protects the consumer from the worst case distribution results. A whitepaper has been developed to provide supporting documentation and the rationale used in the development of this standard. This whitepaper will be published by the SAE as an Aerospace Information Report (AIR6553).
Standard

Groove Design - Metal Face Seal
2019-06-06
CURRENT
AIR1108A
Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS202 thru MS9205) where interchangeability with machined or formed metal seals is desired. For metal o-ring groove designs where inter-changeability is not a requirement refer to ARP 674.
Standard

Screw Threads, Metric Buttress - MJB Profile
2019-01-03
CURRENT
MA1696B
This standard establishes the basic triangular profile for the MJB thread form, the design profiles, standard pitches, tolerance classes, formulae for tolerances and dimensions, tolerance tables, and a system of designations. Because of the specialized application for buttress threads, no preferred diameter-pitch series have been established for this standard and each application will require use of the thread formulae for dimensions and related tolerances given herein for deriving the thread dimensional requirements.
Standard

White Paper to Support Supersession of MIL-S-8879C With AS8879C
2018-08-23
HISTORICAL
AIR5926
This paper was prepared to support supersession of MIL-S-8879C with Screw Thread Conformity Task Force selected industry standard AS8879C, published by the Society of Automotive Engineers (SAE). Other documentation changes will be covered by separate papers. Separate papers are anticipated for thread gaging issues, and thread gage calibration procedures. The STC-TF decided that the thread design standard needed to be completed before thread gage definition could be addressed. Thread gage definition has to be known before calibration procedures can be addressed.
123Next >Last >>
X