Refine Your Search

Topic

Author

Search Results

Standard

Aircraft Ground Deicing/Anti-Icing Processes

2024-04-29
WIP
AS6285E
This SAE Aerospace Standard (AS) establishes the minimum requirements for ground-based aircraft deicing/anti-icing methods and procedures to ensure the safe operation of aircraft during icing conditions on the ground. This document does not specify the requirements for particular aircraft models. NOTE: Refer to particular aircraft operator or aircraft manufacturer’s published manuals and procedures. The application of the procedures specified in this document are intended to effectively remove and/or prevent the accumulation of frost, snow, slush, or ice contamination which can seriously affect the aerodynamic performance and/or the controllability of an aircraft. The principal method of treatment employed is the use of fluids qualified to AMS1424 (Type I fluid) and AMS1428 (Type II, III, and IV fluids). All guidelines referred to herein are applicable only in conjunction with the applicable documents.
Standard

Aircraft Ground Support Equipment – General Requirements

2024-04-26
WIP
ARP1247F
This SAE Aerospace Recommended Practice (ARP) outlines the basic general design requirements for ground support equipment used in the civil air transport industry. It is intended to assist in standardizing requirements for various configurations of equipment. For procurement of equipment, sections of this document should be specified with due consideration of the functional and environmental requirements of the equipment, and to the relative cost of satisfying those requirements.
Standard

Aluminum Alloy, Extruded Profiles (2395-T84), 3.95Cu - 1.15Li - 0.3Ag - 0.5Mg - 0.1Zr, Solution Heat Treated, Stress Relieved by Stretching, and Aged

2024-04-25
CURRENT
AMS4359A
This specification covers an aluminum alloy in the form of extruded rods, bars, and profiles (shapes) 0.040 to 1.500 inches (1.02 to 38.10 mm), inclusive, in thickness, and produced with maximum cross-sectional area of 23.25 square inches (15000 mm2) and a maximum circumscribing circle diameter (circle size) of 15.5 inches (394 mm) (see 2.4.1 and 8.6).
Standard

Titanium Alloy Bars, Forgings, and Flash-Welded Rings, 5Al - 2.5V - 4Sn - 1Co - 0.8Fe Annealed

2024-04-25
CURRENT
AMS6903
This specification covers a titanium alloy in the form of bars, forgings, and flash-welded rings up through 12.000 inches (304.80 mm), inclusive, in diameter or least distance between parallel sides, and stock of any size for forging or flash-welded rings. Bars, forgings, and flash-welded rings with a nominal thickness of 3.000 inches (79.20 mm) or greater shall have a maximum cross-sectional area of 113 square inches (729 cm2) (see 8.5).
Standard

Titanium Alloy Bars, Forgings and Forging Stock, 6.0Al - 6.0V - 2.0Sn, Solution Heat Treated and Aged

2024-04-25
CURRENT
AMS6935D
This specification covers a titanium alloy in the form of bars up through 4.000 inches (101.60 mm) in nominal diameter or least distance between parallel sides, inclusive, forgings of thickness up through 4.000 inches (101.60 mm), inclusive, with bars and forgings having a maximum cross-sectional area of 32 square inches (204.46 cm2), and stock for forging of any size (see 8.6).
Standard

Castings, Classification and Inspection of

2024-04-25
CURRENT
AMS2175B
This specification establishes nondestructive testing methods, sampling frequency, and acceptance criteria for the inspection of metal castings.
X