Refine Your Search

Date

Date

Topic

Topic

Drag Scale models Analysis methodologies Aircraft structures E-25 General Standards for Aerospace and Propulsion Systems

Search Results

Viewing 1 to 20 of 87
123Next >Last >>
Sort by published
Standard

Thread Inspection Practices
2020-02-03
CURRENT
AS5870
This document addresses AS8879 thread inspection issues relating to selection, usage and capability of gages. It addresses the selection of calibrated measurement gages, the need for defined quality metrics, the methodology of determining the appropriate guardband factors, and the minimum inspection requirements for single element pitch diameter gages. Users of this document shall apply the information described herein for the evaluation of the capability of their measurements based on the measurement consumer risk. It involves the analysis of the measurement (product) distribution and biases of both the product and measurement system distributions. It protects the consumer from the worst case distribution results. A whitepaper has been developed to provide supporting documentation and the rationale used in the development of this standard. This whitepaper will be published by the SAE as an Aerospace Information Report (AIR6553).
Standard

Propeller Shaft Ends - Dual Rotation (Engine Supplied Bearing)
2018-11-28
CURRENT
AIR18B
This SAE Aerospace Information Report (AIR) records the results of an investigation of a dual rotation propeller shaft standard for an engine supplied bearing and the reason for deciding that such a bearing is impracticable.
Standard

White Paper to Support Supersession of MIL-S-8879C With AS8879C
2018-08-23
HISTORICAL
AIR5926
This paper was prepared to support supersession of MIL-S-8879C with Screw Thread Conformity Task Force selected industry standard AS8879C, published by the Society of Automotive Engineers (SAE). Other documentation changes will be covered by separate papers. Separate papers are anticipated for thread gaging issues, and thread gage calibration procedures. The STC-TF decided that the thread design standard needed to be completed before thread gage definition could be addressed. Thread gage definition has to be known before calibration procedures can be addressed.
123Next >Last >>
X