Search Results

The estimation of fuel economy benefits gained through improved engine oils using ASTM test procedures is expensive and time consuming. This paper describes a methodology to predict ASTM Sequence VI and VIA fuel economy based on laboratory bench tests. High shear rate viscosities were measured using a tapered bearing simulator and boundary friction coefficients were measured using a Plint reciprocating machine at temperatures used in Sequence VI and VIA tests. Weighted viscosities and weighted friction coefficients were calculated from these measurements using weighting factors identical to those used in the Sequence tests. The measured Sequence VI and VIA fuel economy numbers were correlated with the weighted viscosities and weighted friction coefficients. An excellent correlation was observed between Sequence VIA fuel economy and weighted high shear rate viscosities and friction coefficients whereas a reasonable correlation was observed for Sequence VI fuel economy.

Axle dynamometer tests were carried out to evaluate the effects of rear axle lubricant viscosity-temperature behavior and frictional characteristics on vehicle fuel economy. Using a Ford 9 inch 2.75:1.0 ratio axle, a set of input speed and load conditions was selected to permit simulation of the CVS and EPA highway driving cycles. Lubricant temperature was varied from -30°C to 100°C to simulate seasonal climatic effects. Data obtained for three lubricants differing in viscosity-temperature behavior were interpreted assuming a lubrication model including both elastohydrodynamic and mixed lubrication conditions. From these data, fuel economy projections were made using a vehicle simulation computer program. The results predict that improvements in vehicle fuel economy on the order of a few percent can be made at low temperatures by use of low viscosity synthetic lubricants, but only small effects are projected for the CVS and EPA highway cycles.