Refine Your Search

Date

Date

Topic

Topic

AMS E Carbon and Low Alloy Steels Committee Vehicles, Equipment, and Performance Pressure

Search Results

Viewing 1 to 20 of 75
123Next >Last >>
Sort by published
Standard

Steel, Maraging, Bars, Forgings, Mechanical Tubing, Rings, and Stock for Forgings and Rings, 18.5Ni - 12.0Co - 4.9Mo - 1.40Ti - 0.10Al, Premium Aircraft Quality, Double Vacuum Melted, Annealed (Maraging 350)
2023-11-10
CURRENT
AMS6515C
This specification covers a premium aircraft-quality steel in the form of bars, forgings, mechanical tubing, and flash-welded rings up to 5.000 inches (127.00 mm), inclusive, in diameter or least distance between parallel sides, and stock of any size for forging or flash-welded rings.
Standard

Tolerances Carbon Steel, Sheet, Strip, and Plate
2021-09-29
CURRENT
AMS2232H
This specification covers established inch/pound manufacturing tolerances applicable to carbon steel sheet, strip, and plate ordered to inch/pound dimensions. These tolerances apply to all conditions unless otherwise noted. The term “excl” is used to apply only to the higher figure of the specified range. Tolerances for product sizes not listed herein shall be as agreed upon by purchaser and vendor.
Standard

Heat Treatment of Steel Raw Materials
2020-09-01
CURRENT
AMSH6875C
This specification covers the requirements for heat-treatment of four classes of steel (See 1.2) and the requirements for furnace equipment, test procedures and information for heat-treating procedures, heat-treating temperatures and material (See 6.3) test procedures. This specification is applicable only to the heat treatment of raw material (See 6.3.1); it does not cover the requirements for the heat treatment of steel parts (See 3.4 and 6.3.2). This specification also describes procedures that, when followed, will produce the desired properties and material qualities within the limitations of the respective alloys tabulated in Tables 1A, 1B, 1C and 1D. Alloys other than those specifically covered herein may be heat treated using all applicable requirements of this specification.
Standard

Minimizing Stress Corrosion Cracking in Wrought Forms of Steels and Corrosion Resistant Steels and Alloys
2015-08-10
HISTORICAL
ARP1110C
The purpose of this SAE Aerospace Recommended Practice (ARP) is to provide the aerospace industry with recommendations concerning the minimization of stress corrosion cracking in wrought heat-treatable carbon and low alloy steels and in austenitic, precipitation hardenable, and martensitic corrosion-resistant steels and alloys. The detailed recommendations are based on laboratory and field experience and reflect those design practices and fabrication procedures which should avoid in-service stress corrosion cracking.
Standard

Heat Treatment of Steel Parts General Requirements
2014-04-23
HISTORICAL
AMS2759E
This specification establishes general requirements for the processes listed in 3.3.1 for heat treatment of steel parts (See 8.2.1) by users or their vendors or subcontractors.
Standard

Minimizing Stress Corrosion Cracking in Wrought Forms of Steels and Corrosion Resistant Steels and Alloys
2011-04-12
HISTORICAL
ARP1110B
The purpose of this SAE Aerospace Recommended Practice (ARP) is to provide the aerospace industry with recommendations concerning the minimization of stress corrosion cracking in wrought heat-treatable carbon and low alloy steels and in austenitic, precipitation hardenable, and martensitic corrosion-resistant steels and alloys. The detailed recommendations are based on laboratory and field experience and reflect those design practices and fabrication procedures which should avoid in-service stress corrosion cracking.
123Next >Last >>
X