Search Results

In the present paper, the effect of the clean and cold EGR flow on the performance of a diesel engine running under conventional and Low Temperature Combustion conditions is investigated by means of experimental tests on a single-cylinder research engine. The engine layout was “ad hoc” designed to isolate the effect of the clean and cold recirculated gas flow on the combustion quality. The results have shown that the thermodynamic temperature is the main factor affecting the engine performances, while the effect of a cleaner EGR flow, in terms of lower smoke and unburned compounds (HC and CO), is negligible.

The effect of fuel injection strategy and charge dilution on NOx and soot emissions has been investigated with a modern DI diesel engine. Particulate mass has been measured by a standard smoke meter and soot particles have been characterized by means of time-resolved Laser Induced Incandescence (LII) at the exhaust of the engine. Two steady-state test points have been selected, representative of low and medium load conditions. The influence of the different engine management strategies has been assessed, highlighting the potential of unconventional operating modes to meet forthcoming emission limits.

Combusiton of pine pyrolysis oil droplets was studied at different pressures up to a maximum of 60 bar in a single-droplet combustion chamber. Oil droplets, with diameters between 400 μm and 120 μm were suspended to a thermocouple of to a quartz fiber. Their behavior was followed by means of high-speed digital imaging based on a shadowgraph scheme. About two thousands of frames were collected during every test with acquisition speed between 400 and 4000 frames/s. Droplets were easy to ignite at normal as well as at high pressure. Increasing the pressure the intensity of swelling phenomena, undergone by droplets, decreased and completely disappeared at pressures higher than 20 bar. However, bubbling and foaming were always observed. Liquid-phase pyrolysis and the formation of cenospheres as combustion residual were observed under all the pressure conditions.

Aim of this paper was to assess the feasibility of the application of wood pyrolysis oil (WPO) as a fuel for medium-duty Diesel engines. The experimental activity was carried out both on a diesel injection system and on a DI Diesel engine. High-speed visualization was used to highlight the spray characteristics and an instrumented test bench to evaluate engine performance and emissions. No modification was carried out on the engine and the efforts were addressed to make the WPO compatible with engine operation. Accordingly, WPO was not tested as a pure fuel, but in blends with diglyme and in emulsions with Diesel fuel.

This paper reports on the first successful tests performed on a production D.I. Diesel engine using wood pyrolysis oil (WPO). As reported in literature, any attempt to directly replace Diesel fuel with WPO required extensive modifications to the engine injection system, in order to overcome the intrinsic limits of the oil (poor self-ignition, high acidity and viscosity): new materials, additional pilot injection systems, careful procedures of start-up and shutdown were needed to obtain acceptable operation. Aim of the present work was to assess the limits of utilization of WPO in a strictly stock engine. Therefore, while no modifications at all were carried out on the engine, the efforts were addressed to make the WPO compatible with light-duty Diesel engines. Several long-running tests were performed on a single-cylinder engine, with: blends of WPO with different percentage of oxygenated compounds micro-emulsions of WPO in Diesel fuel standard (commercial) Diesel fuel.