Refine Your Search

Date

Date

Topic

Topic

Wear Titanium alloys AE-8A Elec Wiring and Fiber Optic Interconnect Sys Install Plating Identification Chemicals Diesel / compression ignition engines Radio equipment

Search Results

Viewing 1 to 20 of 62
123Next >Last >>
Sort by published
Standard

EWIS Wiring Insulation Breakdown Testing
2022-09-30
CURRENT
ARP6216
This SAE Aerospace Recommended Practice (ARP) identifies the minimum requirements for the testing of insulated electrical wiring for on-aircraft, aeronautical and aerospace applications. The testing requirements defined herein, ensure that a wire fault can be found safely when using a high potential voltage tester (hipot). This test is intended to aid in finding a breach in the wire insulation, and not for the identification of the resistance of the insulation. The test method defined herein is limited to equipment which ia able to control and limit the DC output to 1500 VDC maximum. This type of wire dielectric tester is typically designed to trip on current leakage and not necessarily on arc detection. This test method is solely designed to identify gross/large wire insulation damage or degradation. For additional related information on this topic and related test methods, refer to the documents cited in Section 2.
Standard

Transmission Lines, Transverse Electromagnetic Mode
2020-10-30
CURRENT
ARP81490B
This document covers the general recommendations for Transverse Electromagnetic Mode (TEM) Transmission Lines intended for use in airborne systems (see 6.2.14). For U.S military applications, TEM Transmission Lines shall meet the requirements in accordance with MIL-T-81490. The follow index lists the recommended requirements and methods covered by the Aerospace Recommended Practice (ARP):
Standard

Design and Handling Guide Radio Frequency Absorptive Type Wire and Cables (Filter Line, AS85485)
2020-01-31
CURRENT
AIR4465A
This document presents design and application information which will allow optimized utilization of filter line wire and cable purchased to AS85485. Filter line wire is defined and design information is presented. The electrical and mechanical performance characteristics of the wire, along with recommended harnessing methods and techniques, are also presented.
Standard

Marking of Electrical Insulating Materials
2019-12-27
CURRENT
AS5942
This specification establishes the performance requirements for the identification of wire and cable by indirect markings that have been applied to electrical insulating materials including heat shrink sleeving, wrap around labels and “tie-on” tags as well as any other types of materials used for indirect marking. This specification covers the processes used to mark these materials, including impact ink marking, thermal transfer, hot stamp, and lasers, etc. This specification does not cover the direct marking on insulated electrical wires and cables.
Standard

Wire and Cable Marking Process, UV Laser
2019-10-21
CURRENT
AS5649A
This standard is applicable to the marking of aerospace vehicle electrical wires and cables using ultraviolet (UV) lasers. This standard specifies the process requirements for the implementation of UV laser marking of aerospace electrical wire and cable and fiber optic cable to achieve an acceptable quality mark using equipment designed for UV laser marking of identification codes on aerospace wire and cable. Wiring specified as UV laser markable subject to AS4373 and which has been marked in accordance with this standard will conform to the requirements of AS50881.
Standard

Etching of Fluoropolymer Insulations
2019-06-11
CURRENT
ARP6167
This SAE Aerospace Recommended Practice (ARP) describes the etching of fluoropolymer electrical wire insulations to ensure that all facets of the process from the chemistry to the processing, to the storage and handling are well defined.
123Next >Last >>
X