Search Results

The main objective of this study is to reduce the aerodynamic drag of tractor-trailer combinations used in the forest industry. In most cases, logging trucks on their return trips are usually travelling in unloaded conditions with upright stakes, which add drag. CFD and wind tunnel testing suggested a drag reduction of up to 35% with no upright stakes, which corresponds to 17% in fuel savings in unloaded conditions. One of the proposed fuel reduction concepts was therefore to have foldable stakes so that the stakes could fold down into a horizontal position while travelling in unloaded conditions. Fuel savings of 15% for a vehicle with stakes in the horizontal position were confirmed with track testing when compared to the fuel consumption of a vehicle with stakes in the vertical position. The coastdown test indicated 28% reduction in drag. The difference in drag reduction between the coastdown test and initial simulation was due to stake size and profile.

The purpose of this study was to evaluate automatic transmissions in a forestry context by comparing their performance with that of standard manual transmissions, and assessing the possibility of improving fuel efficiency by adapting the engine and automatic transmission performances to the vehicle's load. Long-haul test results showed that during the test day, the degradation in driver performance with the manual transmission truck translated into a 2.9% relative increase in fuel consumption when compared with the automatic transmission truck. The fleet data assessment indicated no obvious difference in fuel consumption between the performance of automatic transmissions and manual transmissions. One system for adapting engine performance to vehicle load uses an onboard weigh scale to determine the load status of the vehicle.

Air resistance, after gross vehicle weight, is the largest factor responsible for vehicle energy loss and has an important influence on fuel consumption. The magnitude of aerodynamic drag is affected by the vehicle's shape, frontal area, and travel speed. This study aimed to evaluate several aerodynamic drag reduction measures applicable to class 8 tractor-trailer combinations. The tested aerodynamic devices included trailer aft body rear deflectors (boat tails), trailer skirts, gap deflectors, fuel tank fairings and truck rear-axle fenders. It also assessed the aerodynamic influence of opened doors on an empty wood chip van trailer on the fuel consumption of the tractor-trailer combination. The tests were conducted according to SAE J1321 Joint TMC/SAE Fuel Consumption Test Procedure - Type II.

An integrated adaptive cruise control (ACC) and cooperative ACC (CACC) was implemented and tested on three heavy-duty tractor-trailer trucks on a closed test track. The first truck was always in ACC mode, and the followers were in CACC mode using wireless vehicle-vehicle communication to augment their radar sensor data to enable safe and accurate vehicle following at short gaps. The fuel consumption for each truck in the CACC string was measured using the SAE J1321 procedure while travelling at 65 mph and loaded to a gross weight of 65,000 lb, demonstrating the effects of: inter-vehicle gaps (ranging from 3.0 s or 87 m to 0.14 s or 4 m, covering a much wider range than previously reported tests), cut-in and cut-out maneuvers by other vehicles, speed variations, the use of mismatched vehicles (standard trailers mixed with aerodynamic trailers with boat tails and side skirts), and the presence of a passenger vehicle ahead of the platoon.

The objective of the project was to compare the fuel consumption of a prototype hybrid electric CNG truck with that of two trucks: a CNG truck and a diesel truck for the similar market and operating conditions. The tests were conducted on a test route representative of the conditions encountered by these vehicles in normal driving operations. The test route length was 276 km with a maximum altitude difference of 374 m. The test route had four sections, including a hilly section with a length of 88 km. The result of the comparison between the two CNG trucks was expressed as fuel savings of CNG in percentage. The fuel consumption of the diesel truck was accurately measured using the gravimetric method. The hybrid electric CNG truck showed average fuel savings of 3.6% and demonstrated up to 7.7% in savings for the entire trip compared to the CNG truck.