Search Results

Study of starting friction during the running of the engineering application has an important role in designing them, especially working at low speed and high load conditions. A significant portion of research and development today is concentrated on saving the energy by reducing the friction. The present paper addresses the measurement technique and analysis of the starting friction during the running of the journal bearing. The experiments were performed during the hydrodynamic lubrication regime using SAE 15W-30 lubricating oil. A journal bearing having journal diameter as 22 mm, length/diameter ratio 1 and 0.027 mm radial clearance has been designed and fabricated to test the starting friction. Analysis of starting friction and average friction torque during the running of journal bearing was done at 900, 1150, 1400, 1650, 1900, 2150 and 2400 revolution per minute (rpm) speed of the journal at load values of 250, 400 and 500 N.

Lead (Pb) bronze material is used for the manufacturing of bearings. Lead provides less friction and wear-related properties to bronze. During working of the bearings the lead contained micro-chips mixes with the lubricant oil and makes its disposal difficult. Rotational speed and applied load are the two main parameters on which the working and amount of wear from the bearing depend. So it is important to find out an optimum set of speed and pressure on which a particular bearing should operate to minimize the wear and hence minimize the lead-contaminated lubricating oil. In the present work, Taguchi technique has been used to find out the optimum values of speed and pressure. To measure the specific wear rate (SWR) and coefficient of friction (COF) of the leaded bronze material, it is made to slide on a mild steel material and amount of wear and coefficient of friction has been recorded using a pin on disc machine using ASTM-G99 standards.

Globally, the demand for energy is increasing due to both increase in population and enhancement in the lifestyle of people. Most of the energy demand at present is met from fossil fuels, which are not only exhaustible but also a threat to the environment. Various routes of sustainable energy resources are being explored to address the above-mentioned issues and fuel made from used tyre may be one of the promising options. India is one of the fastest growing economies and every year 10 million new vehicles are registered. Due to poor road conditions, nearly fourfold tyres of this number are dumped as waste. This large stock of dumped tyres are non-biodegradable and creates other problems like a breeding site for mosquitos, or source of pollution in case of accidental fire. In order to cope with the large pile-up of used tyres, pyrolysis of these tyres could be a sustainable route.