Search Results

The California LEV1 II program will be introduced in the year 2003 and requires a further reduction of the exhaust emissions of passenger cars. The cold start emissions represent the main part of the total emissions of the FTP2-Cycle. Cold start emissions can be efficiently reduced by injecting secondary air (SA) in the exhaust port making compliance with the most stringent standards possible. The thermochemical conditions (mixing rate and temperature of secondary air and exhaust gas, exhaust gas composition, etc) prevailing in the exhaust system are described in this paper. This provides knowledge of the conditions for auto ignition of the mixture within the exhaust manifold. The thus established exothermal reaction (exhaust gas post-combustion) results in a shorter time to light-off temperature of the catalyst. The mechanisms of this combustion are studied at different engine idle conditions.

This paper analyses the scavenge process of a conventional two-stroke engine in order to find ways to significantly reduce the scavenge losses by applying a combination of 1D and 3D simulation procedures. A special evaluation method was developed which allows a clear distinction between the main hydrocarbon loss mechanisms. Furthermore, the paper presents an approach to simulate the highly turbulent combustion at a speed of 9000 rpm. The results of the numerical investigations are compared with experimental results. The engine chosen for this purpose was a 64 cm3 four-port production two-stroke engine. The CFD calculations were performed using the finite volume CFD code STAR-CD. The mesh generation process was automated using pro*am. Combustion was modelled with the one-equation Weller flamelet model. The results of the present study show that the combination of 1D and 3D simulation procedures is a powerful tool for further investigations (e.g. stratified charge, GDI).

A previously presented robust and fast diagnostic NOx model was modified into a predictive model. This was done by using simple yet physically-based models for fuel injection, ignition delay, premixed heat release rate and diffusion combustion heat release rate. The model can be used both for traditional high temperature combustion and for high-EGR low temperature combustion. It was possible to maintain a high accuracy and calculation speed of the NOx model itself. The root mean square of the relative model error is 16 % and the calculation speed is around one second on a PC. Combustion characteristics such as ignition delay, CA50 and the general shape of the heat release rate are well predicted by the combustion model. The model is aimed at real time NOx calculation and optimization in a vehicle on the road.

In this paper a fast NOx model is presented which can be used for engine optimization, aftertreatment control or virtual mapping. A cylinder pressure trace is required as input data. High calculation speed is obtained by using table interpolation to calculate equilibrium temperatures and species concentrations. Test data from a single-cylinder engine and from a complete six-cylinder engine have been used for calibration and validation of the model. The model produces results of good agreement with emission measurements using approximately 50 combustion product zones and a calculation time of one second per engine cycle. Different compression ratios, EGR rates, injection timing, inlet pressures etc. were used in the validation tests.

In order to meet future emission standards of small two-stroke engines (CARB 2), detailed knowledge of in-cylinder charge motion and mixture distribution is essential to be able to provide new ways of reducing exhaust emissions. The aim is to minimize fuel short circuiting accompanying the scavenging flow, which in turn leads to high HC emissions. Therefore, an experimental investigation was carried out to investigate the in-cylinder flow structure during the gas exchange process inside a small two-stroke engine. An optically accessible cylinder was fitted to a 64 cm3 two-stroke engine and the transient gas motion examined with Particle-Image-Velocimetry (PIV) under a variety of operating conditions and speeds up to 6000 rpm. The flow was investigated in two vertical cross- sectional planes through the cylinder and in a horizontal plane. The flow was observed through endoscopic optics to overcome the limitations associated with the design of an optical aperture in the small engine.