Refine Your Search

Topic

Search Results

Standard

Etching of Fluoropolymer Insulations

2013-11-11
CURRENT
ARP6167
This SAE Aerospace Recommended Practice (ARP) describes the etching of fluoropolymer electrical wire insulations to ensure that all facets of the process from the chemistry to the processing, to the storage and handling are well defined.
Standard

Wire and Cable Marking Process, UV Laser

2019-10-21
CURRENT
AS5649A
This standard is applicable to the marking of aerospace vehicle electrical wires and cables using ultraviolet (UV) lasers. This standard specifies the process requirements for the implementation of UV laser marking of aerospace electrical wire and cable and fiber optic cable to achieve an acceptable quality mark using equipment designed for UV laser marking of identification codes on aerospace wire and cable. Wiring specified as UV laser markable subject to AS4373 and which has been marked in accordance with this standard will conform to the requirements of AS50881.
Standard

Wire and Cable Marking Process, UV Laser

2007-05-31
HISTORICAL
AS5649
This standard is applicable to the marking of aerospace vehicle electrical wires and cables using ultraviolet (UV) lasers. This standard specifies the process requirements for the implementation of UV laser marking of aerospace electrical wire and cable and fiber optic cable to achieve an acceptable quality mark using equipment designed for UV laser marking of identification codes on aerospace wire and cable. Wiring specified as UV laser markable subject to AS4373 Test Methods for Insulated Electric Wire and which has been marked in accordance with this standard will conform to the requirements of AS50881.
Standard

EWIS Wiring Insulation Breakdown Testing

2017-07-24
CURRENT
ARP6216
This SAE Aerospace Recommended Practice (ARP) identifies the minimum requirements for the testing of insulated electrical wiring for on-aircraft, aeronautical and aerospace applications. The testing requirements defined herein, ensure that a wire fault can be found safely when using a high potential voltage tester (hipot). This test is intended to aid in finding a breach in the wire insulation, and not for the identification of the resistance of the insulation. The test method defined herein is limited to equipment which ia able to control and limit the DC output to 1500 VDC maximum. This type of wire dielectric tester is typically designed to trip on current leakage and not necessarily on arc detection. This test method is solely designed to identify gross/large wire insulation damage or degradation. For additional related information on this topic and related test methods, refer to the documents cited in Section 2.
Standard

Recommended Test Fluids for Electrical Components Used on Aircraft Exterior or for Ground Support Near Aircraft

2012-11-21
CURRENT
ARP5062A
The purpose of this SAE Aerospace Recommended Practice (ARP) is to provide recommended test fluids for testing of electrical components used on aircraft exterior or for ground support near aircraft. These fluids were selected based on a consolidation of test fluids used by military and commercial sources and on review of national and international component specifications. These recommendations are general guidelines. Safety factors for any unusual testing applications or operating conditions should be given special consideration by the designer. The test fluids provided are intended to be recommendations and are not intended to limit or supersede those recommended by aircraft or ground support equipment manufacturers.
X