Search Results

The use of a fuzzy logic controller for an active suspension system on a wheeled vehicle is investigated. Addressing the opposing goals of ride quality and bump stop avoidance are integrated into one control algorithm. Construction of the fuzzy rules base will be discussed comprehensively along with the membership function setup for both the input and output variables. Numerous quarter-car simulation comparisons will be performed of the fuzzy controller versus the standard skyhook damper controller. The comparisons will include a variety of terrain inputs. Laboratory testing of the fuzzy controller on a single wheel station system is also included.

The use of electromechanical actuators for an active suspension on a main battle tank is investigated. A novel approach to the development of the active suspension control algorithms is presented along with simulation results to evaluate the electromechanical design requirements. The optimal electromechanical actuator design is described along with simulated performance results for a one roadwheel station electromechanical active suspension. Follow-up plans for the laboratory testing of a single wheel station system are also included.

In March of 1995, the University of Texas at Austin Center for Electromechanics (UT-CEM) began work on developing active suspension control algorithms for four-wheeled, off-road, rough terrain, vehicles. To serve as a test platform to validate simulations, a four corner test-rig, representing a military HMMWV at one third scale, was designed and fabricated. Multiwheel control algorithms were developed, based on single wheel concepts previously described in SAE publications. The four-wheel test-rig performance compared well with single wheel test-rig performance, showing that the active suspension concepts developed by UT-CEM, which do not require advanced terrain knowledge (i.e., no “look-ahead”), are compatible with full vehicle control.

The University of Texas Center for Electromechanics (UT-CEM) has been developing active suspension technology for off-road vehicles since 1993. The UT-CEM approach employs fully controlled electromechanical actuators to control vehicle dynamics and passive springs to efficiently support vehicle static weight. The project described in this paper is one of a succession of projects toward the development of effective active suspension systems, primarily for heavy off-road vehicles. Earlier projects targeted the development of suitable electromechanical actuators. Others contributed to effective control electronics and associated software. Another project integrated a complete system including actuators, power electronics and control system onto a HMMWV and was demonstrated at Yuma Proving Grounds in Arizona.

The University of Texas at Austin Center for Electromechanics (UT-CEM) has conducted a set of simulations and full-scale experiments to determine suitable shock load design requirements for in-hub (wheel) propulsion motors for hybrid and all-electric combat vehicles. The characterization of these design parameters is required due to recent advancements in suspension technology that have made it feasible to greatly increase the tempo of battle. These suspension technologies allow vehicles to traverse off-road terrains with large rms values at greater speeds. As a result, design improvements for survivability of in-hub motors must be considered. Defining the design requirements for the improved survivability of in-hub motors is the driving factor for this research. Both modeling and experimental results demonstrate several realistic scenarios in which wheel hubs experience accelerations greater than 100g, sometimes at very low vehicle speeds.

A fundamental problem in the design of a remotely controlled handling device is the command and data link. Where the handling device is to have limited mobility a direct-wired system is suitable. Where greater mobility and a large number of control functions are required a multiplex type control system and data link becomes more attractive. For mobility over greater distances, radio control may be used. The Hughes Mobot Mark II is an example of the second system. Technical details of Mobot Mark II are given and experience with reliability, maintainability, and operator training requirements are presented. The adaptation of this control system to a radio control and data link is also outlined.