Refine Your Search

Date

Date

Topic

Topic

E-25 General Standards for Aerospace and Propulsion Systems Thermodynamics Engine mechanical components Seals and gaskets

Search Results

Viewing 1 to 20 of 165
123Next >Last >>
Sort by published
Standard

Groove Design - Metal Face Seal
2013-10-28
HISTORICAL
AIR1108
Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS202 thru MS9205) where interchangeability with machined or formed metal seals is desired. For metal o-ring groove designs where inter-changeability is not a requirement refer to ARP 674.
Standard

Groove Design - Metal Face Seal
2019-06-06
CURRENT
AIR1108A
Groove designs presented herein are applicable for use with machined or formed metal seals which are similar in configuration to those shown in figure 3, which operate under internal pressure or in vacuum service and which have been specifically qualified or recommended by the purchaser or the manufacturer for use with this AIR. They are also applicable for use with metal o-rings (e.g., MS9142, MS202 thru MS9205) where interchangeability with machined or formed metal seals is desired. For metal o-ring groove designs where inter-changeability is not a requirement refer to ARP 674.
Standard

Propeller Shaft Ends - Dual Rotation (Engine Supplied Bearing)
2012-10-19
HISTORICAL
AIR18A
This SAE Aerospace Information Report (AIR) records the results of an investigation of a dual rotation propeller shaft standard for an engine supplied bearing and the reason for deciding that such a bearing is impracticable.
Standard

Propeller Shaft Ends - Dual Rotation (Engine Supplied Bearing)
2018-11-28
CURRENT
AIR18B
This SAE Aerospace Information Report (AIR) records the results of an investigation of a dual rotation propeller shaft standard for an engine supplied bearing and the reason for deciding that such a bearing is impracticable.
Standard

Shaft Nut and Keywasher Installation Dimensions for
2019-07-29
CURRENT
AS1495B
The purpose of this Standard is to provide installation dimensions for shaft nuts and their companion keywasher. The Standard type typically shown on MS9951 and MS9952, but is also suitable for parts which are dimensionally equivalent.
Standard

SHAFT NUT AND KEYWASHER INSTALLATION DIMENSIONS FOR
1979-05-01
HISTORICAL
AS1495
The purpose of this standard is to provide installation dimensions for shaft nuts and their companion keywasher. The standard deals specifically with the design shown on MS9951 and MS9952 but is also suitable for parts which are dimensionally equivalent.
Standard

Shaft Nut and Keywasher Installation Dimensions For
2012-11-01
HISTORICAL
AS1495A
The purpose of this standard is to provide installation dimensions for shaft nuts and their companion keywasher. The standard deals specifically with the design shown on MS9951 and MS9952 but is also suitable for parts which are dimensionally equivalent.
123Next >Last >>
X