This specification covers an aluminum alloy in the form of bars and rods 0.500 inch (12.7 mm) to 8.000 inches (203.2 mm) in nominal diameter or least difference between parallel sides and up to 50 square inches (322.6 square centimeters) in cross-sectional area (see 8.7).
The results of this test are intended to be a useful indication of the resistance to distortion of bare or two-side Alclad, flat sheet aluminum used in chemical milling applications.
This specification covers the specific requirements for 7178 aluminum alloy alclad plate and sheet; the general requirements are covered in AMS-QQ-A-250. The plate and sheet covered by this specification shall be an integral composite product consisting of a heat-treatable aluminum alloy (7178) core with thin layers of an aluminum alloy (7072) anodic to the core and of approximately equal thickness bonded to both surfaces.
Primarily for hydraulic pressure lines. This specification has been 'CANCELLED' by the Aerospace Materials Division, SAE, as of September 1996. Alloy: C65500 UNS Number: C65500
This specification covers a silver alloy in the form of wire, rod, sheet, strip, foil, pig, powder, shot, and chips, and a viscous mixture (paste) of powder in a suitable binder.
This specification covers a leaded red brass alloy in the form of sand and centrifugal castings. These castings have been used typically for parts, such as fittings in fluid conducting lines, where soundness of castings is of prime importance, but usage is not limited to such applications.