Search Results

A method of cleaning lubricating oil on line was investigated using a fine bypass particulate filter followed by an infra red heater. Two bypass filter sizes of 6 and 1 micron were investigated, both filter sizes were effective but the one micron filter had the greatest benefit. This was tested on two nominally identical EURO 1 emissions compliance refuse trucks, fitted with Perkins Phazer 210Ti 6 litre turbocharged intercooled engines and coded as RT320 and RT321. These vehicles had emissions characteristics that were significantly different, in spite of their similar age and total mileage. RT321 showed an apparent heavier black smoke than RT320. Comparison was made with the emissions on the same vehicles and engines with and without the on-line bypass oil recycler. Engine exhaust emissions were measured about every 400 miles. Both vehicles started the test with an oil drain and fresh lubricating oil.

The accumulation and release of particulate matter within the exhaust system of a modern light-duty diesel engine was studied during a step cold start to three steady state load conditions, idle, 10 and 15kW. Changes in particulate mass concentration through the various components of the exhaust system were dependent on the previous short-term history of the engine operation, and on the engine speed reached during cold start. Particulate matter was deposited within the oxidation catalyst when cold and in the downstream exhaust silencer at idle and low power conditions. Particulate matter was released from the first silencer at all three test conditions and this release exceeded the deposition in the downstream silencer and resulted in a net exhaust system particulate blowout, at all three test conditions. This was a large fraction of the tailpipe emissions at all three test conditions.

A method of cleaning diesel engine lubricating oil on-line was investigated using a bypass fine particulate filter followed by an infra-red heater to remove water vapour and light diesel fractions in the oil. The impact of this oil recycler on the gaseous and particulate emissions was investigated over a 300 hour oil age period. A Ford 1.8 litre IDI passenger car diesel engine was used with engine out emission sampled every 15-20 hours. The tests were carried out at 2500rpm (52% of the maximum speed) and 12.3 kW with 47 Nm load (43% of the maximum load and 29% of the maximum power). The EGR level at this condition was 15%. A stop start test cycle was used with a cold start each time and a typical test period of 2-3 hours. The results showed that the recycler had its greatest influence on emissions for fresh oil when there was a large reduction in particulate emissions due mainly to large reductions in the ash, carbon and unburned lubricating oil fractions.

Diesel exhaust particle size distribution and total number concentration were measured at different positions along the exhaust system of a practical light-duty passenger car diesel engine. Continuous particle size measurements during the diesel cold start were made in 12 particle size ranges using the ELPI particle size analyser. Three engine speeds were studied using a step cold start procedure to the set load and speed condition. The exhaust system had an oxidation catalyst with hydrocarbon absorber and two silencers. Particle size distributions were determined upstream and downstream of the catalyst and the two silencers. There were considerable variations in the particle number and size distribution after the cold start. The catalyst was shown to act as a store for fine particles and there were further particle losses across the two silencers.