Search Results

Power steering systems provide significant design challenges. They are detrimental to fuel economy since most require the continuous operation of a hydraulic pump. This generates heat that must be dissipated by fluid lines and heat exchangers. This paper presents a simple one-dimensional transient model for power steering components. The model accounts for the pump power, heat dissipation from fluid lines, the power steering cooler, and the influence of radiation heat from exhaust system components. The paper also shows how to use a transient thermal model of the entire system to simulate the temperatures during cyclic operation of the system. The implications to design, drive cycle simulation, and selection of components are highlighted.

Friction materials used in the brake linings of automobiles, trucks, buses and other vehicles are required to satisfy a number of performance demands: they must provide a dependable, consistent level of friction, excellent resistance to wear, adequate heat dissipation, structural integrity, low cost and, if possible, light weight. No single material can meet all of these often conflicting performance criteria, and as a consequence, multiphase composites have been developed, consisting typically of a dozen or more different materials. The choice of materials is crucial in determining the performance attained, yet to date, braking material compositions have been developed largely on the basis of empirical observations.

One potential fire ignition source in a motor vehicle is the hot surfaces on the engine exhaust system. These hot surfaces can come into contact with combustible and flammable liquids (such as engine oil, transmission fluid, brake fluid, gasoline, or Diesel fuel) due to a fluid leak, or during a vehicle collision. If the surface temperature is higher than the hot surface ignition temperature of the combustible or flammable liquid in a given geometry, a fire can potentially ignite and propagate. In addition to automotive fluids, another potential fuel in post-collision vehicle fires is grass, leaves, or other vegetation. Studies of hot surface ignition of dried vegetation have found that ignition depends on the type of vegetation, surface temperature, duration of contact, and ambient conditions such as temperature and wind speed. Ignition can occur at surface temperatures as low as 300 °C, if the vegetation is in contact with the surface for 10 minutes or longer.

The relationship between pre-braking speed and the length of locked wheel skid marks has been explored in many publications. However, the existing literature does not address the effects of anti-lock braking on pre-braking speed calculations based on the length of tire marks. Anti-lock brake systems reduce the wheel slip and avoid wheel lock (100% slip) to enable a vehicle to achieve high deceleration rates under emergency braking while retaining steering control. Typically, during braking an ABS system will maintain 5-25% slip, and can sometimes leave faint and/or alternating tire marks as opposed to the dark skid marks created by a locked sliding wheel. Instrumented vehicle testing was conducted on a variety of vehicles to quantify the effects of pre-mark braking on overall speed change. From this data, the effective deceleration for the tested road surface was evaluated and compared to existing literature for locked wheel braking.

Low-speed sideswipe collisions between tractor-semitrailers and passenger vehicles can result in large movements and extensive areas of visible damage to the passenger vehicle. However, depending on the specifics of the collision, the resulting crash pulse may be extended, and the vehicle accelerations correspondingly low. Research regarding the impact environment and resulting injury potential of the occupants during these types of impacts is limited. Five full-scale crash tests utilizing a tractor-semitrailer and a passenger car were conducted to explore vehicle responses during these types of collisions for both the passenger car and the tractor-trailer. The test vehicles included a loaded van semitrailer pulled by a tractor and three identical mid-sized sedans. Instrumentation on the sedans included accelerometers and rotational rate sensors, and the vehicle and occupant kinematics were recorded using onboard and off-board real-time and high-speed video cameras.