Search Results

The scope of this work is to examine the use of hydroprossed used cooking oils as substitute for automotive diesel fuel. Hydroprocessing is an alternative method for the transformation of vegetable oils into high quality transport fuels, even if the quality of the oils is low, such as used cooking oils. In the present work, the utilization of hydroprocessed used cooking oil (HUCO) as neat fuel was proved to be very difficult, due to its very poor cold flow properties; therefore, mixtures of the HUCO with low quality middle distillates (a low cetane number gasoil and a light cycle oil) were prepared and evaluated. Throughout the process the formed blends were evaluated according to the european standard EN 590. The following points were mainly recorded: The lower density of HUCO was beneficial, permitting the use of poor quality distillates, in specific concentrations, and the high cetane number of HUCO was appreciable, improving the worse behavior of the other components.

FAME is the most common renewable component of conventional automotive diesel. Despite the advantages, biodiesel is more susceptible to oxidative deterioration and due to its chemical composition as well as its higher affinity to water, is considered to be a favorable substrate for microorganisms. On the other hand, apart from biodiesel, alcohols are considered to be promising substitutes to conventional diesel fuel because they can offer higher oxygen concentration leading to better combustion characteristics and lower exhaust emissions. More specifically, n-butanol is a renewable alcohol demonstrating better blending capabilities and properties when it is added to diesel fuel, as its composition is closer to conventional fuel, when compared ethanol to for example. Taking into consideration the alleged disinfectant properties of alcohols, it would be interesting to examine also the microbial stability of blends containing n-butanol in various concentrations.

In accordance to the current environmental policy of the European Union by 2020, 10% of the transport fuel in every country comes from renewable sources such as biofuels. One of the most popular biofuels, (bio) ethanol is a probable suitable candidate for addition in diesel fuel because of its cleaner combustion and the ability to reduce emissions of gaseous pollutants. However, its use presents some important problems, attributed mainly to its incompatibility with diesel fuel during mixing due to the difference in the polarity. For this reason, substances that act as stabilizers of these mixtures are used, one of the most suitable being butanol. This substance is compatible with diesel fuel and ethanol, acting as a chemical bridge between the two, but also exhibits positive combustion behavior, as it is also an oxygenate that can be produced from renewable sources as well. The aim of this work was to investigate the behavior of diesel-ethanol mixtures using butanol as co-solvent.

Biofuels are a promising alternative to fossil fuels as their availability has been reduced during the last decades and they are the main sources of greenhouse gases emissions. Moreover, the targets of the international regulations include reduction of fossil fuels consumption, and improvement of the sustainability of the vehicle fleet. Blending gasoline with biofuels will result in changes in fuel blending procedures and combustion process especially for the gasoline direct injection (GDI) engines. In this article, flame visualization using chemiluminescence techniques in a Single Cylinder Optical Research Engine (SCORE) is presented, with an adjusted intake pressure of 850 mbar and early intake single injection (280 CAD BTDC), by using 100% hydrocarbon-based gasoline, E10 (90% gasoline - 10% ethanol) and ETBE20 (80% gasoline - 20% ethyl tert-butyl ether). ETBE20 is a potential alternative for E10, as it contains the same amount of renewable fuel and has low water solubility.