Search Results

Recently there has been a greater awareness of the increased risk of certain injuries associated with air bag deployment, especially the risks to small occupants, often women. These injuries include serious eye and upper extremity injuries and even fatalities. This study investigates the interaction of a deploying air bag with cadaveric upper extremities in a typical driving posture; testing concentrates on female occupants. The goals of this investigation are to determine the risk of upper extremity injury caused by primary contact with a deploying air bag and to elucidate the mechanisms of these upper extremity injuries. Five air bags were used that are representative of a wide range of air bag ‘aggressivities’ in the current automobile fleet. This air bag ‘aggressivity’ was quantified using the response of a dummy forearm under air bag deployment.

The torsional natural frequencies of axles equipped with limited slip differential clutches depend on whether or not the tires and clutches are slipping since the effective inertia at each end of the axle is different for slipping and non-slipping conditions. Limited slip axle vibrations are typically analyzed for one tire slipping and the other not since that is the case for which the limited slip clutches are used. Vibrations often arise, however, during normal turning when both drive tires have good traction.

Currently there is no axle test aimed specifically at bearing durability in automotive hypoid axles. Existing axle tests are primarily focused on gear distress and lubricant protection of gears. In light of the new test information showing axle bearing distress, there is a need to develop a new bearing durability test for automotive and truck axle lubricants. To fulfill this need, a new bearing durability test has been developed to better assess lubricant requirements for rolling element bearing durability. Although the final test of an axle lubricant is in a driven automobile or truck, an effective screening test based on actual light duty truck conditions can be used to accelerate lubricant development to enhance bearing performance in hypoid axles. This new test simulates actual road durability tests in the lab. A specific load cycle which retains the critical road test loading conditions reduces test time and helps speed up lubricant development.

A critical market driver for rear axle lubricants continues to be the improved fuel efficiency, which is related to improvements in power transfer efficiency. Power transfer efficiency improvements are achieved with a reduction in the kinematic viscosity (KV) of rear axle lubricants. General Motors (GM) recently reduced the recommended viscosity grade for their rear axle lubricants from the Society of Automotive Engineers standard (SAE) 75W-90 to SAE 75W-85. This reduction in viscosity continues to require the optimization of rear axle lubricants to ensure durability. Lubricants that form thick elastohydrodynamic (EHD) films and are shear stable even when lower kinematic viscosities are required. This work depicts how a rear axle lubricant was developed and improved with the proper selection of base oil and polymer. This newly developed SAE 75W-85 rear axle fluid was incorporated as factory fill in 2019 in T1 LDPU-GMC Sierra and Chevrolet Silverado 1500 series pickup trucks.

A model and simulation results are presented for the torsional dynamics of a rear wheel driveline while the vehicle is coasting in a turn. The model includes the effects of road load and powertrain drag, limited slip differential clutch friction, the inertias of the vehicle, wheels, axles, differential carrier, and driveshaft, the final drive ratio, torsional stiffnesses of the axles and driveshaft, vehicle track width, and radius of the turn. The dynamics of coasting in a turn differ from powered driving due to changes in the inertia loading the driveshaft, the damping effect of the disengaged transmission, and nonlinearities in the clutch friction. Specific focus is given to vibration in the axles and driveshaft due to variations in the torque-speed slope of the clutches, which is determined by the slope of the friction coefficient ‘μ’ versus sliding speed ‘v’ in the limited slip clutches.