This standard covers three basic types of total-temperature-measuring instruments used as a means of determining the total temperature developed by adiabatic heating of the air due to motion of the aircraft through the air.
This recommended practice covers the requirements for gyroscopically stabilized Directional Indicating Systems, which will operate as a 1°/hour latitude corrected, free directional gyro or as a slaved gyro, magnetic compass with 1/2° accuracy.
These recommendations cover the mechanical and electrical installation and installation test procedures for automatic pilots of the type normally used in transport type aircraft. The material in this ARP does not supercede any airworthiness requirement in the Civil Air Regulations.
These recommendations cover the mechanical and electrical installation and installation test procedures for automatic pilots of the type normally used in transport type aircraft. The material in this ARP does not supercede any airworthiness requirement in the Civil Air Regulations.
This SAE Aerospace Standard (AS) covers automatic pilots intended for use on aircraft to automatically operate the primary and trim aerodynamic controls to maintain stable flight and/or to provide maneuvering about any of the three axes through servo control. Automatic control functions essential for primary or augmented flight control are excluded.
This SAE Aerospace Information Report (AIR) is concerned only with aspects directly relating to available accuracy. While well-designed photoelectric, inductive or capacitive readers and pressure regulators, and other accessories are highly desirable for convenience and production rate, they are considered to be outside the scope of this AIR.
This specification covers the design and performance requirements for a single axis, four load-factor level counting accelerometer group referred to hereafter as “equipment.”
This specification covers the design requirements and all performance requirements for procurement of 1 7/8 inch dial pilot’s standby compasses as specified herein.
This specification covers the design requirements and all performance requirements for procurement of 1 7/8 inch dial pilot’s standby compasses as specified herein.
This specification covers the following basic types of instruments, or combinations thereof, intended for use in protecting aircraft power plant installations, auxiliary power plants, combustion heaters and other installation where fuel, oil or similar fires may occur.
This specification covers the following basic types of instruments, or combinations thereof, intended for use in protecting aircraft power plant installations, auxiliary power plants, combustion heaters and other installation where fuel, oil or similar fires may occur.
This standard covers three (3) basic types of flight recorders as defined below: All requirements specified in Sections 3, 4, 5, 6 and 7 of this standard shall be applicable to all recorder types unless otherwise noted.
This standard covers three (3) basic types of flight recorders as defined below: All requirements specified in sections 3, 4, 5, 6 & 7 of this standard shall be applicable to all recorder types unless otherwise noted.