Refine Your Search

Date

Date

Topic

Topic

Engine mechanical components AMS E Carbon and Low Alloy Steels Committee On-board energy sources Electronic control systems Electrical, Electronics, and Avionics Exhaust emissions Thermodynamics Fuel injection

Search Results

Viewing 1 to 20 of 41
123Next >Last >>
Sort by relevance
Standard

Tolerances, Metric Low-Alloy Steel Sheet, Strip, and Plate
2003-03-12
HISTORICAL
MAM2252B
This specification covers established metric manufacturing tolerances applicable to low-alloy steel sheet, strip, and plate ordered to metric dimensions. These tolerances apply to all conditions unless otherwise noted. The term “excl” is used to apply only to the higher figure of the specified range.
Standard

TOLERANCES, METRIC Low-Alloy Steel Sheet, Strip, and Plate
1998-04-01
HISTORICAL
MAM2252A
This specification covers established metric manufacturing tolerances applicable to low-alloy steel sheet, strip, and plate ordered to metric dimensions. These tolerances apply to all conditions unless otherwise noted. The term “excl” is used to apply only to the higher figure of the specified range.
Standard

PISTON RINGS, CENTRIFUGALLY-CAST IRON
1995-05-01
HISTORICAL
AMS7312F
This specification covers a centrifugally-cast, alloyed iron in the form of sleeves for the fabrication of piston rings.
Standard

HEAT TREATMENT Carbon, Low-Alloy, and Specialty Steels
1976-01-01
HISTORICAL
AMS2760
This specification covers the procedure for through-hardening and related heat treatments of carbon, low-alloy, and specialty steel parts to produce specified mechanical properties within the capability of each respective steel.
Standard

Steel Cleanliness, Special Aircraft-Quality Magnetic Particle Inspection Procedure
2015-05-21
HISTORICAL
AMS2304B
This specification covers steel cleanliness requirements in inch/pound units for special aircraft-quality ferromagnetic steels, including hardenable corrosion resistant steels, by magnetic particle inspection methods. This specification contains sampling, sample preparation, inspection procedures and cleanliness rating criteria (See 8.2).
123Next >Last >>
X