Search Results

This paper presents a novel partial flow sampling system for the characterization of airborne exhaust particle emissions. The sampled aerosol is first conditioned in a porous dilutor and then subsequent ejector dilutors are used to decrease its concentration to the range of the instrumentation used. First we examine the sensitivity of aerosol properties to boundary sampling conditions. This information is then used to select suitable sampling parameters to distinguish both the nucleation and the accumulation mode. Selecting appropriate sampling parameters, it is demonstrated that a distinct nucleation mode can be formed and measured with different instruments. Using these parameters we examine the performance of the system over transient vehicle operation. Additionally, we performed calculations of particle losses in the various components of the system which are then used to correct signals from the instruments.

Due to the stringent emission standards set worldwide, particulate matter (PM) emissions from diesel vehicles have been significantly curtailed in the last decade, and are expected to be reduced even further in the future. This evolution has brought forward two main issues: whether PM emissions should only be regulated for diesel vehicles and whether gasoline powered vehicles can be further neglected from PM emission inventories. This paper addresses these issues comparing the characteristics of particle emissions from a current diesel passenger car, a gasoline one and two small two-wheelers. It is shown that the gasoline car is a negligible source of particle emissions while the two-wheelers may be even more significant particle sources than the diesel car.

The Particle Measurement Programme (PMP), initiated from different Member States, aims at developing a method and sampling recommendations for a particle number-based emission standard, to support future emission regulation in Europe. In this paper we applied two different commercially available dilution systems (an FPS from Dekati Ltd and an MD19-2E from Matter Engineering AG) to record the particle emissions of a Euro II and a Euro III diesel passenger car. The latter was also fitted with a diesel particle filter (DPF) to simulate future emission levels. At their present development stage, both dilution systems failed to totally comply with all requirements of the PMP protocol. The main problems appeared to be the lack of accurate determination of the dilution ratio and the inability to reach the desired dilution temperature.