Search Results

Much has been written about reconstruction techniques and testing methods concerning vehicle rollovers. To date, most of the literature describes rollovers as one-dimensional events. Rollovers account for a disproportionate fraction of serious injuries and fatalities among all motor vehicle accidents. The three-dimensional nature of rollover sequences in which a rolling vehicle experiences multiple ground contacts contributes to the environment where such injuries occur. An analytical technique is developed to model the airborne segments of a rollover sequence as a parabolic path of the vehicle center of gravity. A formulation for the center of gravity descent from maximum elevation to full ground contact is developed. This formulation contains variables that may be readily determined from a thorough reconstruction. Ultimately, this formulation will also provide a vertical ground impact velocity at contact.

To date, the most commonly used rollover test device has been the rollover dolly described in the SAE J2114 recommended practice, which is commonly referred to as the “208 rollover dolly.” However, for a number of reasons, the rollover dolly has never been accepted as a standard for rollover testing. One of the primary limitations of the rollover dolly has been the controllability of the first roof-to-ground impact. A new rollover test device, known as the Controlled Rollover Impact System (CRIS), was presented at the SAE Congress in March 2001. This device allows the roll, pitch, and yaw angles, roll rate, translational velocity, and drop height of the vehicle to be specified for the first roof-to-ground impact. One objective of the current study was to compare the vehicle dynamics produced by each test device using an Econoline-350 van as the test vehicle.

A follow-up case study on rollover testing with a single full-size sport utility vehicle (SUV) was conducted under controlled real-world conditions. The purpose of this study was to conduct a well-documented rollover event that could be utilized in evaluating various methods and techniques over the phases associated with rollover accidents. The phases documented and discussed, inherent to rollovers, are: pre-trip, trip, and rolling phases. With recent advances in technology, new devices and techniques have been designed which improve the ability to capture and document the unpredictable dynamic events surrounding vehicle rollovers. One such device is an inertial measurement unit (IMU), which utilizes GPS technology along with integrated sensors to report and record measured dynamic parameters real-time. The data obtained from a RT-4003 IMU device are presented and compared along with previous test data and methodology.

Three rollcaged and three production roof vehicles were exposed to matched-pair rollover impacts using the Controlled Rollover Impact System (CRIS). The roof-to-ground contacts were representative of severe impacts in previous rollover testing and real world rollovers. The seat belted dummies measured nearly identical head impacts and neck loads with or without the rollcage, despite significant roof crush in the production roof vehicles. Roof crush had no measurable influence on the severity of the head accelerations and neck loads.