Search Results

Pollutant emissions are a major issue from all existing internal combustion engines, especially from Diesel engines, with nitrogen oxides (NOx) and particulate matter (PM) receiving particular attention. Simultaneous reduction of NOx and PM often presents a challenge to Diesel engine researchers because of the inherent trade-off between them due to their contradictory responses to oxygen content in a fuel. The use of liquid or gaseous biofuels in internal combustion engines, benefits in the reduction of life-cycle CO2 emissions, but suffers from unfavorable NOx/PM emissions trade-off. Hence, it is essential to moderate NOx/PM emissions trade-off in order to effectively use the Rapeseed Methyl Ester (RME) fuel as an alternative to the fossil Diesel fuel in Diesel engines.

The amount of fresh air induced into the cylinder is the main parameter to be taken into account when developing the engine control laws. However, the instantaneous amount of induced air cannot be directly measured. Additionally, as the engine air ducting becomes more and more complex (high and low pressure exhaust gas recirculation, variable valve timing, pneumatic hybridization…), models used to develop engine control laws must be as predictive as possible. It has therefore been decided to use 1d aerodynamics simulation to provide accuracy to the control laws development and validation process. Commercial engine codes have been tested but did not give satisfactory results in terms of calculation time and flexibility. Additionally, in the case where no experimental data are available to determine valve discharge coefficient, simulation results were in total disagreement with the engine bench measurements.

In the last decade, the drastic strengthening of engine emission regulations has conducted the automotive industry towards more and more sophisticated engine control strategies requiring more and more sensor inputs and actuator outputs. The testing and setting up of the ECUs implementing such strategies becomes more and more difficult, requiring numerous engine tests on test benches. ECUTEST is a hardware and software package from KADRA CONSULTANTS that offers the following features: Simulation of sensors including variable reluctance sensor, lambda sensor, knock sensor… Measurement of output signals (injection, ignition, EGR…) timing and amplitude. A predefined test pattern can be replayed on the ECU to perform end of line testing. A real-time model can be used for testing and setting up embedded closed loop strategies. The present paper will cover the implementation of a real-time SI engine model on ECUTEST.

Torque based engine control seems to be the trend for the future for powertrain management (automatic gearbox, hybrid vehicles). Today, torque estimation is best achieved using cylinder pressure transducers. This paper proposes a method to achieve a good accuracy of the torque using Bézier curves to reconstruct the cylinder pressure peak from the low frequency embedded pressure measurements. As is, IMEP cannot be used on a cycle to cycle basis for engine torque control, due to the very high cycle to cycle variability of SI engines. To improve the quality of the IMEP feedback data, this paper proposes a moving horizon filtering method.

To meet future pollutant emissions standards, it is crucial to be able to estimate the cycle by cycle composition of the combustion chamber charge. This charge consists of fresh air, fuel and residual gas from the previous cycle. Unfortunately, the residual gas fraction cannot be directly measured. Therefore, a model of residual gas fraction as a function of engine parameters and operating parameters has been developed. The model has been calibrated with exhaust pipe hydrocarbon measurements using a successive dilution method.

Recrystallized Silicon carbide (R-SiC) honeycombs have been widely used over the last couple of years as filtration media for diesel particulates filtration in passenger cars applications. Although such filters are very reliable thanks to SiC good properties and smart designs, existing devices can still be improved. This paper describes several new features developed for R-SiC honeycomb filters in order to increase their durability and reduce their cost. Durability improvements can be obtained through the optimization of different filter properties such as thermo-mechanical resistance and thermal diffusivity. Specific tests have been performed in order to optimize new R-SiC filters.