Refine Your Search

Topic

Search Results

Standard

IGNITION PEAK VOLTAGE MEASUREMENTS

1994-06-01
CURRENT
AIR84A
These specifications contain general information about the characteristics of ignition systems and measuring techniques; recommended types of voltage dividers and output indicators; calibration procedures.
Standard

Interrelation of Engine Design and Burner Configuration with Selection and Performance of Electrical Ignition Systems for Gas Turbine Engines

1963-07-01
HISTORICAL
AIR784
To describe typical ignition systems in general usage and their parameters that warrant considerations during the development of a gas turbine engine. To describe those parameters in gas turbine engine design and, in particular, burner configurations that influence the type selection and performance of the ignition system. To indicate the areas where future work may uncover important effects having a direct bearing on certain interrelated parameters, with resultant benefits to both the engine and ignition designers..
Standard

INTERRELATION OF ENGINE DESIGN AND BURNER CONFIGURATION WITH SELECTION AND PERFORMANCE OF ELECTRICAL IGNITION SYSTEMS FOR GAS TURBINE ENGINES

1995-06-01
CURRENT
AIR784C
To describe typical ignition systems in general usage and their parameters that warrant consideration during the development of a gas turbine engine. To describe those parameters in gas turbine engine design and, in particular, burner configurations that influence the type selection and performance of the ignition system. To indicate the areas where future work may uncover important effects having a direct bearing on certain interrelated parameters, with resultant benefits to both the engine and ignition designers.
Standard

OSCILLOSCOPIC METHOD OF MEASURING SPARK ENERGY

1978-06-01
CURRENT
ARP1278
This report describes basic method for measurement of spark energy on all types of capacitance discharge exciters. Reference is made to other methods which may be used if limitations are observed.
Standard

Magnetos, Aircraft, Mountings For

1997-04-01
CURRENT
AS12
This specification covers three types of flanges for magneto mountings as follows: 1. Two-bolt Flange, 2. Three-bolt Flange, and 3. Four-bolt Flange.
Standard

Magnetos, Aircraft, Installation Of

1941-11-01
CURRENT
AS14
This Aerospace Standard establishes the diameter - pitch combinations of ISO metric 60 screw threads recommended for use in the aerospace industry for metric module shaft of bearing retaining screw threads.
X