Search Results

The low-NOx regulation for heavy duty trucks proposed by California’s Air Resources Board (CARB) will present a significant challenge to truck, engine and aftertreatment system manufacturers. This regulation will include a new test cycle representative of low-load operation. With low-load cycles, NOx conversion by the SCR (selective catalytic reduction) system is limited primarily by the exhaust temperature; thus, thermal management will dominate development. Simulation can be used to examine different thermal management strategies, and to define high-level requirements for new components. In this study, modeling was used to investigate SCR performance on two different low-load cycles, including the one selected by CARB for the low-NOx regulation. First, the “thermal deficit” of the cycle was quantified using a constant heat input.

2010 and future EPA regulations introduce stringent Oxides of Nitrogen (NOx) reduction targets for diesel engines. Selective Catalytic Reduction (SCR) of NOx by Urea over catalyst has become one of the main solutions to achieve these aggressive reductions. As such, urea solution is injected into the exhaust gas, evaporated and decomposed to ammonia via mixing with the hot exhaust gas before passing through an SCR catalyst. Urea mixers, in this regard, are crucial to ensure successful evaporation and mixing since its liquid state poses significant barriers, especially at low temperature conditions that incur undesired deposits. Intensive efforts have been taken toward developing such urea mixers, and multiple criteria have been derived for them, mainly including NOx reduction efficiency and uniformity. In addition, mixers must also satisfy other requirements such as low pressure drop penalty, mechanical strength, material integrity, low cost, and manufacturability.

An active diesel particulate filter (DPF) regeneration system is evaluated, which applies secondary fuel injection (SFI) directly within the exhaust system upstream of a diesel oxidation catalyst (DOC). Diesel fuel is oxidized in the presence of a proprietary catalyst system, increasing exhaust gas temperatures in an efficient and controlled manner, even during low engine-out gas temperatures. The exotherms produced by secondary fuel injection (SFI) have been evaluated using two different DOC volumes and platinum catalyst loadings. DOC light-off temperatures were measured using SFI under steady-state conditions on an engine dynamometer. A ΔT method was used for the light-off temperature measurements – i.e., the minimum DOC inlet gas temperature at which the exothermic reaction increases the outlet gas temperature 20°C or greater than the inlet temperature.

In order to satisfy China IV (equivalent to EU IV) emission regulations, an unconventional design concept was proposed with injector closely coupled with SCR can body. The benefit of this design is that the urea decomposition pipe was removed or drastically shortened, resulting in much smaller packaging space and lower cost of the whole system. However, the resulting short urea mixing distance generates concerns on low urea mixing efficiency and risks of urea deposits. In particular, airless urea injectors tend to generate incomplete evaporation of urea water solution, resulting in high risks of urea deposits. New aftertreatment mixing structures need to be developed to resolve these technical challenges.

New emissions standards for oxides of nitrogen (NOx) in on-road diesel vehicles are effective in 2010, and a common approach applies urea selective catalytic reduction (SCR). Urea is injected into the exhaust and decomposes to form ammonia, which chemically reacts with NOx as it passes through an SCR catalyst. Ammonia is corrosive and negatively affects typical stainless steels used in exhaust applications, but these corrosive impacts have not yet been quantified in an exhaust system. Two unique corrosion tests are performed on a number of various stainless steel samples, illustrating such performance concerns with 409, while offering alternatives with much better performance, including cost-effective options. The method applied is described, yielding performance criteria through appearance, weight loss, and corrosion pit depth.