Search Results

This study experimentally investigates the impact of Miller cycle strategies on the combustion process, emissions, and thermal efficiency in heavy-duty diesel engines. The experiments were conducted at constant engine speed, load, and engine-out NOx (1160 rev/min, 1.76 MPa net IMEP, 4.5 g/kWh) on a single cylinder research engine equipped with a fully-flexible hydraulic valve train system. Early Intake Valve Closing (EIVC) and Late Intake Valve Closing (LIVC) timing strategies were compared to a conventional intake valve profile. While the decrease in effective compression ratio associated with the use of Miller valve profiles was symmetric around bottom dead center, the decrease in volumetric efficiency (VE) was not. EIVC profiles were more effective at reducing VE than LIVC profiles. Despite this difference, EIVC and LIVC profiles with comparable VE decrease resulted in similar changes in combustion and emissions characteristics.

On-road emission measurements of 23 VN-trucks on a randomly chosen driving cycle, consisting of 10 miles two-lane and 8 miles four-lane road, showed tailpipe NOx emissions on fleet average of 0.96 g/bhp-hr, or 1.06 g/bhp-hr when including the time the exhaust gas temperature was below 200°C. Complementary measurements in a SET-cycle (13 point OICA -cycle) on a chassis dynamometer showed a tailpipe emission of 0.008 g PM per bhp-hr. Moreover, cost analysis show that the diesel fuel consumption remains unchanged whether the truck running on ULSD is equipped with a Combined Exhaust gas AfterTreatment System (CEATS) installed or not.

A large percentage of on-highway tractors today have air suspensions. Air suspensions require some type of control system to adjust the ride height. This system is usually referred to as a Load Leveling System. These systems come in a variety of different configurations but all basically have the same functions. When designed correctly, the system can reduce driveline vibration, reduce air consumption (improving compressor life and fuel efficiency), provide an accurate 5th wheel height and improve the ride quality. This paper explores how the characteristics of the leveling system affect the roll stability. One and Two-valve systems are considered, as well as, the position of the valve, response times, valve deadband and the systems response to an off-center load. Notably not every conceivable condition has been considered.

A test protocol previously developed for automotive applications was adapted to evaluate the performance of a climate control system for a heavy-duty truck. Human subjects, as well as a test system composed of a high-resolution passive sensor manikin and a human thermal model, were employed to evaluate thermal comfort perception. Testing was performed in a climate-controlled wind tunnel equipped with a dynamometer. The truck’s HVAC system performance was evaluated in a −10 °C environment. Additionally, the test protocol was designed to explore a large range of thermal sensation and comfort states. Subjective responses, including thermal sensation and comfort, as well as thermo-physiological state information, quantified by skin temperatures measured across the body, were obtained from the human test participants and compared to that which was indicated by the test system.

The increasing importance of reducing greenhouse gas emissions and the ongoing evolution of vehicle-to-vehicle connectivity technologies have generated significant interest in platooning for commercial vehicles, where two or more vehicles travel in same traffic lane in relatively close proximity. This paper examines the effect of platooning on four increasingly aerodynamic tractor-trailer configurations, using a Lattice Boltzmann based CFD solver. Each platoon consisted of three identical tractor-trailer configurations traveling in the same lane at 65mph. Two different vehicle to vehicle gaps were studied, 5m and 9m, in addition to singleton (solitary) vehicles, representing an effectively infinite gap. Aerodynamic drag for the lead, middle, and trailing vehicle in the platooning configurations were compared to the corresponding single vehicle tractor-trailer configuration.