Refine Your Search

Date

Date

Topic

Topic

Textile and Flexible Plastics Committee No Topic Selected Design Engineering and Styling Transmissions Water

Search Results

Viewing 1 to 20 of 30
12Next >Last >>
Sort by relevance
Standard

DYNAMIC FLEX FATIGUE TEST FOR SLAB POLYURETHANE FOAM
1969-03-01
HISTORICAL
J388_196903
This SAE Recommended Practice describes a laboratory test procedure for evaluating the loss of thickness and the amount of structural breakdown of slab polyurethane foam seating materials. A test specimen is measured for thickness under a specified load and subsequently subjected simultaneously to compressive and shear deformation in a controlled atmosphere. This is accomplished by subjecting the foam to a rolling shearing action under a constant load for a specified number of cycles. Specimen thickness under a constant load is obtained after a 1 hr recovery period following dynamic fatigue to determine loss in foam thickness.
Standard

Standard Classification System for Fiberboards
2014-06-04
HISTORICAL
J1323_201406
This SAE Standard provides a means for specifying or describing the pertinent properties of fiberboards for automotive applications. The materials normally specified by this standard are defined in SAE J947. The test methods commonly used for fiberboards are defined in SAE J315.
Standard

Accelerated Exposure of Automotive Exterior Materials Using a Controlled Irradiance Water-Cooled Xenon Arc Apparatus
2008-01-11
CURRENT
J1960_200801
This test method specifies the operating procedures for a controlled irradiance, water-cooled xenon arc apparatus used for the accelerated exposure of various automotive exterior materials. This standard is limited to the models of xenon arc test apparatus specified in the Section on Apparatus. All other models of xenon arc test apparatus must use SAE J2527 to perform the test conditions specified in SAE J1960. SAE J2527 is the performance standard based on the test parameters of SAE J1960. Use of xenon arc test apparatus to perform SAE J2527 must be agreed upon by contractual parties.
Standard

Accelerated Exposure of Automotive Interior Trim Components Using a Controlled Irradiance Water Cooled Xenon-Arc Apparatus
2008-01-11
CURRENT
J1885_200801
This test method specifies the operating procedures for a controlled irradiance, water cooled xenon-arc apparatus used for the accelerated exposure of various automotive interior trim components. Test durations, as well as any exceptions to the sample preparation and performance evaluation procedures contained in this document, are covered in material specifications of the different automotive manufacturers. This standard is limited to the models of xenon arc test apparatus specified in the Section on Equipment. All other models of xenon arc test apparatus must use SAE J2412 to perform the test conditions specified in SAE J1885. SAE J2412 is the performance standard based on the test parameters of SAE J1885. Use of xenon arc test apparatus to perform SAE J2412 must be agreed upon by contractual parties.
12Next >Last >>
X