Search Results

A decade of industrial experience with Exa's CFD software, PowerFLOW, has matured the simulation software to the point where the geometric modeling process is now the bottleneck to efficiency and effectiveness. Simply put, the actual CAE simulation event is now fast enough and accurate enough to drive design intent; however, the geometric design process that supplies alternative models to the software is not fast enough to keep up with the critical path of the design cycle. If CAE tools in general are to play in important role in creating design intent rather than simply verifying completed design work, then the modeling process which drives them will have to improve. In the context of this paper, geometric design involves both Class A exteriors and under-hood geometries. Two pieces of software have been developed to help in this area: PowerWRAP and PowerCLAY.

A numerical investigation of automobile sunroof buffeting on a prototype sport utility vehicle (SUV) is presented, including experimental validation. Buffeting is an unpleasant low frequency booming caused by flow-excited Helmholtz resonance of the interior cabin. Accurate prediction of this phenomenon requires accounting for the bi-directional coupling between the transient shear layer aerodynamics (vortex shedding) and the acoustic response of the cabin. Numerical simulations were performed using the PowerFLOW code, a CFD/CAA software package from Exa Corporation based on the Lattice Boltzmann Method (LBM). The well established LBM approach provides the time-dependent solution to the compressible Navier-Stokes equations, and directly captures both turbulent and acoustic pressure fluctuations over a wide range of scales given adequate computational grid resolution.

A computational analysis of underbody windnoise sources on a production automobile at 180 km/h free stream air speed and 0° yaw is presented. Two different underbody geometry configurations were considered for this study. The numerical results have been obtained using the commercial software PowerFLOW. The simulation kernel of this software is based on the numerical scheme known as the Lattice-Boltzmann Method (LBM), combined with a two-equation RNG turbulence model. This scheme accurately captures time-dependent aerodynamic behavior of turbulent flows over complex detailed geometries, including the pressure fluctuations causing wind noise. Comparison of pressure fluctuations levels mapped on a fluid plane below the underbody shows very good correlation between experiment and simulation. Detailed flow analysis was done for both configurations to obtain insight into the transient nature of the flow field in the underbody region.