Refine Your Search

Topic

Search Results

Standard

Wiring Aerospace Vehicle

2003-08-06
HISTORICAL
AS50881B
This specification covers all aspects from the selection through installation of wiring and wiring devices used in aerospace vehicles. Aerospace vehicles include airplanes, helicopters, lighter-than-air vehicles, and missiles.
Standard

WIRING, AEROSPACE VEHICLE

1998-04-01
HISTORICAL
AS4897A
This specification covers all aspects from the selection through installation of wiring and wiring devices used in aerospace vehicles. Aerospace vehicles include airplanes, helicopters, lighter-than-air vehicles, and missiles.
Standard

WIRING, AEROSPACE VEHICLE

1998-04-01
HISTORICAL
AS50881
This specification covers all aspects from the selection through installation of wiring and wiring devices used in aerospace vehicles. Aerospace vehicles include airplanes, helicopters, lighter-than-air vehicles, and missiles.
Standard

Ultraviolet (UV) Laser Marking Performance of Aerospace Wire Constructions

2015-12-20
HISTORICAL
AIR5558
The purpose of this report is to provide information on the results of ultra violet (UV) laser marking and mark contrast measurement of a wide range of aerospace wire and cable constructions, the specifications for most of which do not state specific requirements for laser markability. The contents of this document are for information and guidance only. It is not intended that it be used as the basis for marking process specifications or standards, which are covered by AS5649 Wire and Cable Marking Process, UV Laser.
Standard

Mitigating Wire Insulation Damage During Processing and Handling

2019-12-27
CURRENT
AIR5717
Wire and cable products progress through a series of handling or operational steps from the time they leave the manufacturer, and until a finished harness or assembly is ready for installation on a vehicle. Throughout these many steps, environmental or processing conditions may be present which can generate damage detrimental to the wire or cable and/or its intended application.
Standard

Marking of Electrical Insulating Materials

1998-07-01
HISTORICAL
AS81531
This specification establishes performance requirements for markings that have been applied to electrical insulating materials (see 6.1).
Standard

Marking of Electrical Insulating Materials

2019-12-27
CURRENT
AS5942
This specification establishes the performance requirements for the identification of wire and cable by indirect markings that have been applied to electrical insulating materials including heat shrink sleeving, wrap around labels and “tie-on” tags as well as any other types of materials used for indirect marking. This specification covers the processes used to mark these materials, including impact ink marking, thermal transfer, hot stamp, and lasers, etc. This specification does not cover the direct marking on insulated electrical wires and cables.
Standard

EWIS Wiring Insulation Breakdown Testing

2022-09-30
CURRENT
ARP6216
This SAE Aerospace Recommended Practice (ARP) identifies the minimum requirements for the testing of insulated electrical wiring for on-aircraft, aeronautical and aerospace applications. The testing requirements defined herein, ensure that a wire fault can be found safely when using a high potential voltage tester (hipot). This test is intended to aid in finding a breach in the wire insulation, and not for the identification of the resistance of the insulation. The test method defined herein is limited to equipment which ia able to control and limit the DC output to 1500 VDC maximum. This type of wire dielectric tester is typically designed to trip on current leakage and not necessarily on arc detection. This test method is solely designed to identify gross/large wire insulation damage or degradation. For additional related information on this topic and related test methods, refer to the documents cited in Section 2.
X