Search Results

This SAE Standard covers thin wall, low tension primary cable intended for use at 50 V or less in surface vehicle electrical systems.

This SAE Standard covers general requirements and terminal interface dimensions of various sizes of pin and receptacle type terminals.

This SAE Standard covers general requirements and terminal interface dimensions of various sizes of pin and receptacle type terminals.

This SAE Recommended Practice defines recommended test methods and general performance requirements of single-pole and multi-pole connectors for on-board electrical wiring harnesses of electric or hybrid powered road vehicles operating at voltages between 50 and 600 V AC or DC rms and those circuits using copper wire only. These requirements are not intended for connections internal to electrical/electronic modules or complete subassemblies. This document applies to connectors designed to be disconnected in the case of repair and/or maintenance after mounting in the vehicle. This document excludes one-part connections, i.e., where one part of the connection has direct contact to the pattern of the circuit board. Duty cycles are considered to be application specific and are not specified in this document; however, these effects must be considered during design. The Recommended Practice for High Voltage Wiring Assembly is contained in SAE J1673.

The purpose of this SAE Recommended Practice is to establish minimum performance and user information requirements for battery booster cable sets. Such sets may be used to provide a temporary connection of a surface vehicle battery to another similar battery to provide emergency power when required. This recommended practice DOES NOT ENDORSE NOR RECOMMEND the potentially hazardous procedure of jump starting a vehicle.

This report relates to recommendations and specifications governing the classification, composition, test procedures, and properties of printed circuits commonly used to replace cable in automotive low voltage systems. It is not applicable to miniature circuits for solid state devices, high impedance or high voltage functions.

This report relates to recommendations and specifications governing the classification, composition, test procedures, and properties of printed circuits commonly used to replace cable in automotive low voltage systems. It is not applicable to miniature circuits for solid state devices, high impedance or high voltage functions.

This report relates to recommendations and specifications governing the classification, composition, test procedures, and properties of printed circuits commonly used to replace cable in automotive low voltage systems. It is not applicable to miniature circuits for solid state devices, high impedance or high voltage functions.

This SAE Recommended Practice covers the application of primary wiring distribution system harnesses to automotive, truck, and similar type vehicles. This is written principally for new vehicles but is also applicable to rewiring and service. It covers the areas of performance, operating integrity, efficiency, economy, uniformity, facility of manufacturing, and service. This practice applies to wiring systems of less than 50 V.