Search Results

It has been proposed that downspeeding combined with high boost levels would effectively reduce fuel consumption in heavy-duty diesel engines. Under low-speed and high-boost operating conditions, however, the in-cylinder gas pressure, which acts on the piston crown, is greater than the piston inertia force (such that there is no force reversal), over the entire range of crank angles. Therefore, the piston pin never lifts away from the main loading area (the bottom) of the connecting rod small-end bushing where the contact pressure against the piston pin is highest. In such operating conditions, lubricant starvation is easily induced at the interface between the piston pin and small-end bushing. Through carefully devised engine tests, the authors confirmed that the piston pin scuffing phenomenon arises when the boost pressure exceeds a critical value at which the no-force reversal condition appears.

Future emission standards for heavy duty diesel engines will require extensive development using an integrated approach. This paper describes the latest results from HINO heavy duty diesel engine combustion research program. Improvement of the NOx/particulate/fuel economy trade off requires fuel injection equipment of Pump Line Nozzle (PLN) System and unit injector with high pressure capability, injection rate control and timing control, and a combustion system matched with high pressure injection. Combustion characteristics (ignition delay, combustion period, heat release curve), fuel consumption, particulate, and exhaust gas emission of each injection system are compared and discussed. The unit injector system has an advantage of lower particulate level, especially dry soot, than the Pump Line Nozzle system. The potential for further improvement through engine modification and aftertreatment is also discussed.

The application of high-efficiency diesel engines, hybrid systems, waste heat recovery (WHR) systems, aftertreatment systems, and advanced drivetrains were all examined as possible approaches to improve the fuel consumption of heavy-duty, long-haul commercial trucks that mainly drive on highways. In this study, the strategies that were employed in an effort to improve the fuel consumption performance of the diesel engine itself and the results of evaluating and testing the actual engine are reported.

In heavy duty (HD) trucks cruising on expressway, about 60% of input fuel energy is wasted as losses. So it is important to recover them to improve fuel economy of them. As a waste heat recovery system, a Rankine cycle generating system was selected. And this paper mainly reports it. In this study, engine coolant was determined as main heat source, which collected energies of an engine cooling, an EGR gas and an exhaust gas, for collecting stable energy as much as possible. And the exergy of heat source was raised by increase coolant temperature to 105 deg C. As for improving the system efficiency, saturation temperature difference was expanded by improving performance of heat exchanger and by using high pressure turbine. And a recuperator which exchanges heat in working fluid between expander outlet and evaporator inlet was installed to recover the heat of working fluid at turbine generator. Then a working fluid pump was improved to reduce power consumption of the system.