Search Results

For optimum efficiency, the direct injection (DI) gasoline engine requires two operating modes to cover the full load/speed map. For lower loads and speeds, stratified charge operation can be used, while homogeneous charge is required for high loads and speeds. This paper has focused its attention on the latter of these modes, where the performance is highly dependent on the quality of the fuel spray, evaporation and the air-fuel mixture preparation. Results of quantitative and qualitative Laser Induced Fluorescence (LIF) measurements are presented, together with shadow-graph spray imaging, made within an optically accessed DI gasoline engine. These are compared with previously acquired air flow measurements, at various injection timings, and with engine performance and emissions data obtained in a fired single cylinder non-optical engine, having an identical cylinder head and piston crown geometry.

Two optical techniques together with a CFD simulation have been used to study the interaction of intake airflow with the injected fuel spray in a motored direct injection gasoline engine. The combustion chamber was of a pent-roof construction with the side-mounted injector located low down between the inlet valves injecting at a 54° angle to the cylinder axis. The two-dimensional piston bowl shape allowed optical access for the Mie scatter technique to be used to investigate the liquid fuel behaviour in the central axial plane of the cylinder lying midway between the two inlet valves and passing through the centre line of the injector nozzle. A second set of images was obtained using backlighting, this time looking through the glass cylinder liner directly towards the injector. The in-cylinder simulation was run using the VECTIS software. Measurements and simulations were conducted for a range of early SOI timings between 20° and 80° ATDC.

This paper investigates the application of a Bottoming Cycle (BC) applied to a 10-litre (L) heavy duty Diesel engine for potential improvements in fuel efficiency. With the main thermodynamic irreversibility in the BC due to the temperature difference between the heat source and the working fluid, a proper selection of the working fluid and its operating condition for a given waste heat is the key in achieving high overall conversion efficiency. The paper reviews a fluid selection methodology based on thermodynamic/thermo-physical and environmental/safety properties. Results are presented using seven pure, dry, isentropic and wet working fluids (synthetic, organic and inorganic) operating with expansion starting from the saturated vapour, superheated vapour, supercritical phase, saturated liquid, and two-phase. Efficiency improvements by recovering Charge Air Coolers (CAC) and Exhaust Gas Recirculation (EGR) cooler heat on two engine platforms were calculated.

The research presented here aims at providing a deeper understanding of the formation of nitric oxide in diesel combustion. To this end, in-cylinder distributions of nitric oxide (NO) were acquired by laser-induced fluorescence (LIF) in a rapid compression machine at conditions representative of a modern diesel passenger vehicle. In particular, the effects of injection and in-cylinder pressure on NO formation were investigated temporally and spatially to offer new insight into the formation of NO. Excitation and collection strategies were notably fine-tuned to avoid the collection of spurious signal due to oxygen (O₂) fluorescence. NO fluorescence was first recorded slightly after the onset of the diffusion flame and until late in the expansion stroke. The early low levels of NO were located on the lean side of the high density of hydroxyl radicals (OH).

The conventional Diesel cycles engine is now approaching the practical limits of efficiency. The recuperated split cycle engine is an alternative cycle with the potential to achieve higher efficiencies than could be achieved using a conventional engine cycle. In a split cycle engine, the compression and combustion strokes are performed in separate chambers. This enables direct cooling of the compression cylinder reducing compression work, intra cycle heat recovery and low heat rejection expansion. Previously reported analysis has shown that brake efficiencies approaching 60% are attainable, representing a 33% improvement over current advanced heavy duty diesel engine. However, the achievement of complete, stable, compression ignited combustion has remained elusive to date.