Search Results

The inedible portion of plant biomass in closed regenerative life support systems must be reprocessed producing recyclable by-products such as carbon dioxide, sugars, and other useful organic species. High solids biomass slurries containing up to 27 wt% were successfully prepared in a stirred batch reactor and then pumped using a single piston valveless pump. Wheat straw, potato, and tomato crop residues were acid hydrolyzed using 1.2 wt% sulfuric acid at 180°C and 1.2 MPa for 0.75-1.5 hours. Viscosity for a 25 wt% acid hydrolyzed wheat straw emulsion (Bingham-plastic) was 6.5 centipoise at 3 cm/sec and 25°C.

This paper describes current work at NASA Ames Research Center on the development of compaction technologies for near and far term space missions. Current efforts involve the development of compactor concepts for lunar missions as outlined in the new Space Exploration Initiative and for far term space missions such as a lunar outpost or Mars exploration mission. The current efforts include the analysis and investigation of compactor design concepts for the Crew Exploration Vehicle and also the design and manufacture of a heat melt compactor for longer term missions.

A step in the development of advanced regenerative life support systems is to produce simulation models to guide experimentation and hardware development. This paper discuses the development of detailed simulation models of water reclamation processors using the ASPEN PLUS™ simulation program. Individual models have been developed for Vapor Compression Distillation (VCD), Vapor Phase Catalytic Ammonia Removal (VPCAR) and Supercritical Water Oxidation (SCWO). This paper outlines the methodology which is used to complete this work and discusses the insights which are gained by this type of model development. A discussion of how modeling predictions are used to direct future work in modeling and experimentation is also presented. The initial set of modeled processors were VCD, VPCAR, and SCWO. Future work will cover the modeling of other processors. These models will be linked to form subsystem level models, and evaluations will be performed on various configurations.

Solid Waste Management (SWM) systems of current and previous space flight missions have employed relatively uncomplicated methods of waste collection, storage and return to Earth. NASA's long-term objectives, however, will likely include human-rated missions that are longer in both duration and distance, with little to no opportunity for re-supply. Such missions will likely exert increased demands upon all sub-systems, particularly the SWM system. In order to provide guidance to SWM Research and Technology Development (R&TD) efforts and overall system development, the establishment of appropriate SWM system requirements is necessary. Because future long duration missions are not yet fully defined, thorough mission-specific requirements have not yet been drafted.

In February 2004 NASA released “The Vision for Space Exploration.” The goals outlined in this document include extending the human presence in the solar system, culminating in the exploration of Mars. A key requirement for this effort is to identify a safe and effective method to process waste. Methods currently under consideration include incineration, microbial oxidation, pyrolysis, drying, and compaction. Although each has advantages, no single method has yet been developed that is safe, recovers valuable resources including oxygen and water, and has low energy and space requirements. Thus, the objective of this work is to develop a low temperature oxidation process to convert waste cleanly and rapidly to carbon dioxide and water. Previously, TDA Research, Inc. demonstrated the potential of a low temperature dry oxidation process using ozone in a small laboratory reactor.

Waste management is a vital function of spacecraft life support systems as it is necessary to meet crew health and safety and quality of life requirements. Depending on the specific mission requirements, waste management operations can include waste collection, segregation, containment, processing, storage and disposal. For the Crew Exploration Vehicle (CEV), addressing volume and mass constraints is paramount. Reducing the volume of trash prior to storage is a viable means to recover habitable volume, and is therefore a particularly desirable waste management function to implement in the CEV, and potentially in other spacecraft as well. Research is currently being performed at NASA Ames Research Center to develop waste compaction systems that can provide both volume and mass savings for the CEV and other missions.

A Microwave Powered Solid Waste Stabilization and Water Recovery Prototype system has been developed for the treatment of solid waste materials generated during extended manned space missions. The system recovers water initially contained within wastes and stabilizes the residue with respect to microbial growth. Dry waste may then be safely stored or passed on to the next waste treatment process. Using microwave power, water present in the solid waste is selectively and rapidly heated. Liquid phase water flashes to steam and superheats. Hot water and steam formed in the interior of waste particles create an environment that is lethal to bacteria, yeasts, molds, and viruses. Steam contacts exposed surfaces and provides an effective thermal kill of microbes, in a manner similar to that of an autoclave. Volatilized water vapor is recovered by condensation.

A Microwave Enhanced Freeze Drying Solid Waste (MEFDSW) processor was delivered to NASA-Ames Research Center by Umpqua Company having been funded through a Small Business Innovative Research Phase II program. The prototype hardware was tested for its performance characteristics and for its functionality with the primary focus being the removal of water from solid wastes. Water removal from wastes enables safe storage of wastes, prevents microbes from growing and propagating using the waste as a substrate and has potential for recovery and reuse of the water. Other objectives included measurements of the power usage and a preliminary estimate of the Equivalent System Mass (ESM) value. These values will be used for comparison with other candidate water removal technologies currently in development.

Of the many competing technologies for resource recovery from solid wastes for long duration manned missions such as a lunar or Mars base, incineration technology is one of the most promising and certainly the most well developed in a terrestrial sense. An incinerator was used to recover and recycle part of the waste produced during the Early Human Testing Initiative Phase 3 (EHTI 3) at Johnson Space Center. The fluidized bed incinerator developed for the EHTI testing was a joint initiative between Ames Research Center, University of Utah and Johnson Space Center. Though in no way an optimized system at that time, the fluidized bed combustor fulfilled the basic requirements of a resource recovery system. Valuable data was generated and problem areas, technology development issues and future research directions were identified during the EHTI testing.

Newly outlined missions in the Vision for U.S. Space Exploration include extended human habitation on Mars. During these missions, large amounts of waste materials will be generated in solid, liquid and gaseous form. Returning these wastes to Earth will be extremely costly, and increase the opportunity for back contamination. Therefore, it is advantageous to investigate the potential for wastes to remain on Mars after mission completion. Untreated, these wastes are a reservoir of live/dead organisms and molecules considered “biomarkers” (i.e., indicators of life). If released to the planetary surface, these materials can potentially interfere with exobiology studies, disrupt any existent martian ecology and pose human safety concerns. Waste Management (WM) systems must therefore be specifically designed to control release of problematic materials both during the active phase of the mission, and for any specified post-mission duration.

The elemental composition of food consumed by astronauts is well defined. The major elements carbon, hydrogen, oxygen, nitrogen and sulfur are taken up in large amounts and these are often associated with the organic fraction (carbohydrates, proteins, fats etc) of human tissue. On the other hand, a number of the elements are located in the extracellular fluids and can be accounted for in the liquid and solid waste fraction of humans. These elements fall into three major categories - cationic macroelements (e.g. Ca, K, Na, Mg and Si), anionic macroelements (e.g. P, S and Cl and17 essential microelements, (e.g. Fe, Mn, Cr, Co, Cu, Zn, Se and Sr). When provided in the recommended concentrations to an adult healthy human, these elements should not normally accumulate in humans and will eventually be excreted in the different human wastes.

A microwave powered solid waste stabilization and water recovery prototype was delivered to Ames Research Center through an SBIR Phase II contract awarded to Umpqua Research Company. The system uses a container capable of holding 5.7 dm3 volume of waste. The microwave power can be varied to operate either at full power (130 W) or in a variable mode from 0% and 100%. Experiments were conducted with different types of wastes (wet cloth, simulated feces/diarrheal wastes, wet trash and brine) at different levels of moisture content and dried under varying microwave power supply. This paper presents the experimental data. The results provide valuable insight into the different operation modes under which the prototype can be used to recover water from the wastes in a space environment. Further investigations and testing of the prototype are recommended.

A variety of techniques, including supercritical water oxidation, fluidized bed combustion, and microwave incineration have been applied to the destruction of solid wastes produced in regenerative life support systems supporting long duration manned missions. Among potential problems which still deserve attention are the need for operation in a variety of gravitational environments, and the requirement for improved methods of presenting concentrated solids to the reactor. Significant improvements in these areas are made possible through employment of the magnetically assisted gasification process. In this paper, magnetic methods are described for manipulating the degree of consolidation or fluidization of granular ferromagnetic media, for application in a gravity independent three step solid waste destruction process.

A Microwave Enhanced Solid Waste Freeze Drying Prototype system has been developed for the treatment of solid waste materials generated during extended manned space missions. The system recovers water initially contained within wastes and stabilizes the residue with respect to microbial growth. Dry waste may then be safely stored or passed on to the next waste treatment process. Operating under vacuum, microwave power provides the energy necessary for sublimation of ice contained within the waste. This water vapor is subsequently collected as relatively pure ice on a Peltier thermoelectric condenser as it travels en route to the vacuum pump. In addition to stabilization via dehydration, microwave enhanced Freeze Drying reduces the microbial population (∼90%) in the waste.

The electrosynthesis of expendable reagents including acids, bases, and oxidants from simple salts or salt mixtures has been demonstrated using a variety of electrochemical cells. A five chambered electrodialytic water splitting (EDWS) cell with bipolar membranes was utilized to efficiently convert sodium sulfate, sodium chloride, potassium nitrate, and potassium chloride to conjugate acids and bases. With the same cell, selective segregation of cations and anions from mixed salt solutions occurred, resulting in relatively pure acids and bases. These results suggest that pure acids and bases can be produced from composite spacecraft brines. Chemical oxidants such as sodium and ammonium persulfate were also synthesized with high current efficiencies by the electrooxidation of salts and acids in a two chambered electrochemical cell.

In this paper we have developed a unique approach to providing the elements required for crop production in a steady-state condition, which is essential for Space habitats. The approach takes into consideration human elemental requirements and crop requirements for healthy growth and develops a method for the calculation of the rates of nutrient uptake for the different elements for different crops. The uptake rates can be used to calculate the rate of nutrient supply required in the hydroponic solution. This approach ensures that crops produced will not have excessive levels of elements that may be harmful to humans. It also provides an opportunity to optimize the processes of crop production and waste processing through highly controlled feed rates.

Advanced space life support systems, especially systems that include growing plants to produce food, require the recovery of resources - primarily carbon dioxide and water - from various hydrocarbon wastes. Supercritical water oxidation (SCWO) of wastes is one of several possible techniques for oxidizing waste organics to recover the carbon dioxide and water. Supercritical water oxidation has the advantages of fast kinetics, complete oxidation, and the minimization of undesirable side products. However, the SCWO process requires further development before the process can be implemented in space life systems. One of the SCWO development needs is in the area of destruction of insoluble solids - such as inedible biomass or human wastes. Insoluble solids have to be introduced into a SCWO reactor as particles, and it can be expected that the particle size of the solids will affect the rate of reaction.

This paper presents the results from a joint research initiative between NASA Ames Research Center and Lawrence Berkeley National lab. The objective of the research is to produce activated carbon from life support wastes and to use the activated carbon to adsorb and chemically reduce the NOx and SO2 contained in incinerator flue gas. Inedible biomass waste from food production is the primary waste considered for conversion to activated carbon. Results to date show adsorption of both NOx and SO2 in activated carbon made from biomass. Conversion of adsorbed NOx to nitrogen has also been observed.

NASA Ames Research Center and Lawrence Berkeley National lab have completed a three-year joint NRA research project on the use of waste biomass to make a gaseous contaminant removal system. The objective of the research was to produce activated carbon from life support wastes and to use the activated carbon to adsorb and remove incineration flue gas contaminants such as NOx. Inedible biomass waste from food production was the primary waste considered for conversion to activated carbon. Previous research at NASA Ames has demonstrated the adsorption of both NOx and SO2 on activated carbon made from biomass and the subsequent conversion of adsorbed NOx to nitrogen and SO2 to sulfur. This paper presents the results testing the whole process system consisting of making, using, and regenerating activated carbon with relevant feed from an actual incinerator. Factors regarding carbon preparation, adsorption and regeneration are addressed.

Long duration missions pose substantial new challenges for solid waste management in Advanced Life Support (ALS) systems. These possibly include storing large volumes of waste material in a safe manner, rendering wastes stable or sterilized for extended periods of time, and/or processing wastes for recovery of vital resources. This is further complicated because future missions remain ill-defined with respect to waste stream quantity, composition and generation schedule. Without definitive knowledge of this information, development of mission requirements is hampered. Additionally, even if waste streams were well characterized, other operational and processing needs require clarification (e.g. resource recovery requirements and planetary protection constraints). Therefore, the development of solid waste management (SWM) subsystem requirements for long duration space missions is an inherently uncertain, complex and iterative process.