Search Results

This technical information report specifies a guideline for the hardware requirements for fueling a Hydrogen Surface Vehicle (HSV) with compressed hydrogen storage rated at a Nominal Working Pressure of 70 MPa. It contains a description of the receptacle geometry and optional communication hardware and communications protocol to refuel the HSV. The intent of this document is to enable harmonized development and implementation of the hydrogen fueling interfaces. It is intended to be utilized for hydrogen vehicle field evaluations until enough information is collected to enable standardization. The receptacle portion of this document is to be reevaluated utilizing international field data in approximately two (2) years and subsequently superseded by SAE J2600 in the 2009 timeframe.

this is the first report that has been generated for TC7, Subcommittee on Biodiesel in Railroad Applications.

This report is the result of a Cooperative Research Project undertaken by representatives from GM, Chrysler, Ford, BP Oil, Arco, and Sun Refining and Marketing Co. An information-packed guide, the report includes background information, describes M85 specifications, details the physical properties of M85 vs. gasoline, and examines the effect of M85 on various aspects of vehicle performance and safety. Issued September 1991.

This specification and its supplementary detail specifications cover adhesion promoters in liquid form.

This report lists military and industry specifications and standards which are commonly used in aerospace gas turbine fuel systems. It is intended as a supplement to specifications MIL-F-3863, MIL-F-17874 and MIL-F-8615. Revisions and amendments which are current for these specifications and standards are not listed.

This Aerospace Recommended Practice includes the following areas: basis for system requirements; selection of materials coupled with hazards and safety; configuration of design; system operation; and evalua tion testing.

This report summarizes data and background relative to age control of specific classes of those nitrile type synthetic elastomers used in sealing devices which are resistant to petroleum base hydraulic fluids, lubricating oils and aircraft fuels. This includes, but is not limited to, those nitrile (NBR or BUNA-N) elastomers specifically covered by Section I of MIL-STD-1523.

No scope available.

No scope available.

This procedure is intended to apply to fuel pumps.

This specification covers minimum requirements for brake temperature monitoring equipment whenever used on any type and model of civil aircraft. It shall be the responsibility of the purchaser to determine the compatibility of these requirements with the application aircraft and to specify requirements in excess of these minimums as necessary.

This procedure is intended to apply to all pumps downstream of engine inlet.

This procedure is intended to apply to all pumps down stream of engine inlet.

This procedure is intended to apply to any aircraft fuel pump which supplies liquid hydrocarbon fuel either directly to an aircraft engine or to another pump mounted on an aircraft engine, except that it is not intended to apply to a fuel pump mounted in a fuel tank.

This Aerospace Recommended Practice (ARP) covers a brief discussion of the icing problem in aircraft fuel systems and different means that have been used to test for icing. Fuel preparation procedures and icing tests for aircraft fuel systems and components are proposed herein as a recommended practice to be used in the aircraft industry for fixed wing aircraft and their operational environment only. In the context of this ARP, the engine is not considered to be a component of the aircraft fuel system, for the engine fuel system is subjected to icing tests by the engine manufacturer for commercial and particular military applications.