Search Results

Bogie-type suspensions for trucks are comprised of two axles and a central spring pack on each side of the truck chassis. Bogie suspensions have a good load distribution between the axles and are used for severe applications in trucks, in off-road conditions thereby subjecting them to extreme stain and load. In today’s competitive market scenario, it of utmost importance to minimize down time in commercial vehicles as it directly corresponds to loss in business which leads to customer dissatisfaction. It is therefore essential to optimize and select the right material for each component in the bogie suspension system. This paper deals with the material selection and testing of one such component - Bogie Wear Pad. The bogie wear pad undergoes sliding friction throughout its lifetime during loading and unloading of bogie suspension. Three different materials are selected and their wear is measured under the same conditions of loading.

Buses have been main means of mass transport in organized as well as unorganized sectors in India. Though the art and science of Chassis Designing had been practiced and matured by all Indian OEMs, Body design had long not been accorded high priority by them. Till 1989, there was no comprehensive set of rules enforced. Bus designs were developed with scant regard for safety and emission. OEMs sold their products in the form of drive away chassis and the Body Design & Body Building was largely left to Body Builders, many of whom employed poor design, build and quality control practices. Spurious materials, parts, non-uniform construction resulted in number of accidents and many of them were fatal. Central Motor Vehicle Rules (CMVR) kicked-in 1st July 1989. With roll out of CMVR, various safety related features like entry/exit door, emergency exits, window frames, their locations, dimensions and designs were defined.

The automotive industry needs sustainable seating products which offer good climate performance and superior seating comfort. The safety requirement is always a concern for current seating systems. The life of the present seating system is low and absorbs moisture over a period of time which affects seat performance (cushioning effect). Recycling is one of the major concerns as far as polyurethane (PU) is concerned. This paper presents the development of an alternative material which is eco-friendly and light in weight. Thermoplastic Polyolefin (PO) materials were tried in place PU for many good reasons. It is closed cell foam which has better tear and abrasion resistance. It doesn't absorb water and has excellent weathering resistance. Also it has a better cushioning effect and available in various colours. Because of superior tear resistance, it is possible to eliminate upholstery and would reduce system level cost.