Search Results

NHTSA released the FMVSS226 Standard in 2011, and defined the requirements for ejection mitigation systems, which limit the linear travel of headform by 100mm. In China regulations, there are similar requirements starting in 2021. Therefore, on the basis of the existing airbag design, adding the rollover protection function becomes a challenge for the airbag development. During the development of the curtain airbag, the cushion design, inflator type, and the fold pattern, all have an important influence on the airbag unfolding direction, the airbag positioning time and the airbag internal pressure, and then significantly affect the occupant protection performance afterwards. In order to reduce the cost and shorten the development time, it is necessary to predict the process of cushion deployment kinematics and the internal pressure of the airbag with high refinement, and based on it to predict and evaluate the FMVSS226 ejection mitigation performance.

A methodology has been implemented to calculate local turbulent flame speeds for spark ignition engines accurately and on-the-fly in 3-D CFD modeling. The approach dynamically captures fuel effects, based on detailed chemistry calculations of laminar flame speeds. Accurately modeling flame propagation is critical to predicting heat release rates and emissions. Fuels used in spark ignition engines are increasingly complex, which necessitates the use of multi-component fuels or fuel surrogates for predictive simulation. Flame speeds of the individual components in these multi-component fuels may vary substantially, making it difficult to define flame speed values, especially for stratified mixtures. In addition to fuel effects, a wide range of local conditions of temperature, pressure, equivalence ratio and EGR are expected in spark ignition engines.

An air-cooled, four-stroke, 125 cc electronic gasoline fuel injection SI engine for motorcycles is altered to burn ethanol fuel. The effects of nozzle orifice size, fuel injection duration, spark timing and the excess air/ fuel ratio on engine power output, fuel and energy consumptions and engine exhaust emission levels are studied on an engine test bed. The results show that the maximum engine power output is increased by 5.4% and the maximum torque output is increased by 1.9% with the ethanol fuel in comparison with the baseline. At full load and 7000 r/min, HC emission is decreased by 38% and CO emission is decreased 46% on average over the whole engine speed range. However, NOx levels are increased to meet the maximum power output. The experiments of the spark timing show that the levels of HC and NOx emission are decreased markedly by the delay of spark timing.

For cold gas Inflator, high refinement of ultimate pressure load forecast of inflator housing is one key of Inflator development. For inflator housing hydro-burst test ultimate load calculation, nonlinear finite element software for high precision results. At beginning, the material parameters of inflator housing for simulation is correlated. The FEA material model adopts the stress-strain data from uniaxial tensile experiments. Considering the geometrical nonlinearity resulting from large deformation as well as material nonlinearity from plastic hardening, the whole tensile process from tensile deformation to failure of the specimen is simulated. Numerical results show that the simulation is appropriate to predict the entire deformation process, and simulation results of ultimate tensile load, X-shape distribution of concentrated instability zone, the fracture location and inclined angle all agrees with that of test results.

A novel reciprocating engine version of oxy-fuel combustion cycle combined with water direct injection (known as internal combustion rankine cycle) is presented in this paper. Water is injected near top dead center to control the reaction rate of the oxy-fuel mixture, as well as the peak in-cylinder temperature. The evaporation of the water mist will increase the mass of working gas inside the cylinder, and enhances the thermo efficiency and MEP. Moreover, the injected water is heated up through heat exchangers by both engine coolant and exhaust gas, and the waste heat is effectively recovered this way. This study investigates the combustion and emission characteristics of ICRC under different engine loads based on a single-cylinder, air-cooled SI engine fueled with propane. An extra diesel injector is employed to inject water with high injection temperature (160°C).