Refine Your Search

Date

Date

Topic

Topic

MTC1, Earthmoving Machinery Engine mechanical components Electric power Chassis

Search Results

Viewing 1 to 20 of 25
12Next >Last >>
Sort by title
Standard

DRAWBAR TEST PROCEDURE FOR CONSTRUCTION, FORESTRY, AND INDUSTRIAL MACHINES
1986-05-01
HISTORICAL
J872_198605
This SAE Standard specifies a test method to measure the drawbar pull performance of self-propelled construction, forestry, and industrial machines and their combinations with mounted and/or trailed equipment, with or without payload, as listed in SAE J1116. It covers the following criteria measured against travel speed: drawbar pull, drawbar power, and wheel or track slip.
Standard

Earthmoving Machinery—Coupling of Attachments to Skid Steer Loaders
2000-06-28
HISTORICAL
J2513_200006
This SAE Standard sets forth standard dimension requirements for the loader attachment bracket and attachment interface to allow interchangeability of attachments on skid steer loaders whose operating mass (see SAE J/ISO 6165) is 4,500 kg or less. Narrow skid steer loaders may have a width that does not allow compliance with this standard. The design of the loader attachment bracket locking system is not restricted by this standard and is left to the discretion of the manufacturer.
Standard

Hydraulic Backhoe Lift Capacity
2012-05-11
CURRENT
J31_201205
This standard applies to hydraulically operated backhoes (as defined in SAE J1116) This standard describes a uniform "over end" and "full swing arc" lifting capacity rating for backhoes. It is based on the actual capacity of the machine to lift and support a load under stable conditions. Rated lift capacities will be specified for both the boom and the dipperstick and will be shown on a lift capacity chart Figure 1.
Standard

IDENTIFICATION TERMINOLOGY—PIPELAYERS
1980-06-01
HISTORICAL
J1295_198006
This standard applies to machines which are designed to raise, lower, and carry pipe and loads of similar nature. The term pipelayer does not include tractors or loaders with side booms which are optional attachments, manufacturer or dealer-installed, to machines as defined in SAE J1057. Note: Some related standards will apply equally to pipelayers and to tractors and loaders with side boom. Two such standards are SAE J743 and ANSI B30.14.
Standard

Lift Capacity Calculation Method Scrap and Material Handlers
2019-04-15
CURRENT
J2518_201904
This SAE Standard provides a uniform method to calculate the lift capacity of scrap and material handlers, establishes definitions and specifies machine conditions for the calculations. This document applies to scrap and material handlers as defined in SAE J2506 that have a 360 degrees continuous rotating upper structure. It does not apply to equipment that is incapable of lifting a load completely off the ground. This document applies to those machines that are crawler, wheel, rail and pedestal or stationary mounted.
Standard

Nomenclature - Hydraulic Backhoes
2018-11-20
HISTORICAL
J326_201811
This SAE standard includes hydraulic backhoes which have no more than 190 degrees of rotational swing and are mounted on wheeled tractors and crawler tractors. Illustrations used are not intended to include all existing commercial machines or to be exact descriptions of any particular machine. The illustrations have been chosen to describe the principles to be used in applying this standard.
Standard

Nomenclature - Hydraulic Backhoes
2012-11-01
HISTORICAL
J326_201211
This SAE Standard includes hydraulic backhoes which have no more than 190 degrees of rotational swing, and are mounted on wheel tractors and crawler tractors. Illustrations used are not intended to include all existing commercial machines or to be exact descriptions of any particular machine. The illustrations have been chosen to describe the principles to be used in applying this standard.
12Next >Last >>
X