Search Results

Species analyses have been performed on engine-out and tailpipe hydrocarbon mass emissions to help understand why fuels with higher T50 and/or T90 distillation temperatures produce higher engine-out and tailpipe hydrocarbon emissions and why fuels with higher T90 distillation temperatures produce higher engine-out and tailpipe specific reactivities. Species analyses were also performed to examine the effects of fuel sulfur level on engine-out and tailpipe species and specific reactivities. These analyses were performed on three different test-vehicle fleets representing varying levels of emissions control technology and the effect of emissions control technology was examined. Individual hydrocarbon species concentrations in both the engine-out and tailpipe were found to correlate linearly with the concentrations of the same species in the fuel, implying that a small fraction of the fuel escapes the combustion process and conversion over the catalyst.

Modal analyses have been performed on engine-out and tailpipe hydrocarbon mass emissions to help understand why fuels with higher T50 and/or T90 distillation temperatures produce somewhat higher engine-out hydrocarbon emissions and substantially higher tailpipe hydrocarbon emissions. Modal analyses were also performed to examine how increased fuel sulfur increases tailpipe hydrocarbon emissions and to identify which gasoline properties in this study are responsible for the lower tailpipe hydrocarbon emissions with reformulated gasolines. These analyses were performed on three different test vehicle fleets representing varying levels of emissions control technology. The modal analyses showed that the substantially higher tailpipe hydrocarbon emissions from fuels with high T50 and/or T90 distillation temperatures result primarily from these fuels producing substantially higher engine-out hydrocarbon emissions during the first cycle of the Federal Test Procedure (FTP).

Exhaust emissions of three vehicles fueled with compressed natural gas (CNG) were compared with emissions of three counterpart gasoline vehicles. The natural gas vehicles were tested on four CNG fuels covering a wide range of pipeline natural gas compositions. The gasoline vehicles were tested on AQIRP Industry Average gasoline and a reformulated gasoline meeting California 1996 regulatory requirements. Nonmethane hydrocarbon (NMHC) and toxic air pollutant emissions of the CNG vehicles were about one-tenth those of their counterpart gasoline vehicles, while methane emissions were about ten times those of the gasoline vehicles. Carbon monoxide (CO) and nitrogen oxides (NOx) emissions were more variable among the three vehicle pairs. CO emissions ranged from 20 to 80% lower with CNG than with gasoline, and NOx ranged from 80% lower with CNG to equivalent to gasoline.

Exhaust and evaporative emissions from three flexible/variable fuel vehicles (FFV/VFV) were measured as the vehicles operated on E85 fuel (a mixture of 85% ethanol and 15% gasoline) or on gasoline. One vehicle was a production vehicle designed for ethanol fuels and sold in 1992-93 and the other two vehicles were prototypes which were recalibrated 1992 model year methanol FFV's. The gasolines tested were Industry Average Fuel A and a reformulated gasoline Fuel C2 that met California 1996 regulatory requirements. The gasoline component of Fuel E85 was based on the reformulated gasoline. The major findings from this three-vehicle program were that E85 reduced NOx 49% compared to Fuel A and 37% compared to Fuel C2, but increased total toxics 108% (5 mg/mi) and 255% (20 mg/mi), respectively, primarily by increasing acetaldehyde. The NOx effect was significant for both engine-out and tailpipe emissions.

Three-day diurnal SHED evaporative emissions were measured in a fleet of ten Auto/Oil current (1989) and 2 older (1984) vehicles using Auto/Oil Industry Average fuel. SHED temperature cycled each 24-hour period from 72 to 96 F (22.2 to 35.5C). Measurements included speciation of individual hydrocarbons in the SHED as well as total mass emissions at the end of each of the three 24-hour test periods. Previous evaporative emission studies provided evidence that permeation and/or fuel seepage could contribute significantly to the mass of diurnal and hot soak emissions. Data from this investigation were used to quantify the contribution of liquid fuel to total SHED emissions during diurnal testing. A calculation method, based on the concentration of 29 select hydrocarbons in the SHED, is presented to apportion SHED emissions between those associated with liquid fuel losses and those associated with fuel tank head space vapor losses.

A two-phase test program designed to investigate the effects of Reid vapor pressure, T50, and oxygenates on hot-start and driveability performance of vehicles operated at high and low altitude in high and intermediate ambient temperature ranges was conducted during July and August of 1992. Twenty 1983 - 1992 model-year vehicles were tested on a set of eighteen fuels which included six hydrocarbon-only fuels, six gasoline-ethanol blends, and six gasoline-MTBE blends. Fuel-injected vehicles showed very few demerits and were insensitive, in most cases, to the fuel variables studied. By comparison, carbureted vehicle's demerit levels were three times the level associated with fuel injected vehicles. Statistically significant degradation of driveability was demonstrated in these vehicles when tested on fuels with low T50 and low RVP. Driveability problems related to low T50 fuels were frequently symptomatic of vapor lock.

Species analyses have been performed on engine-out and tailpipe hydrocarbon mass emissions to help understand why fuels with increasing amounts of heavy hydrocarbon constituents produce significantly higher tailpipe hydrocarbon emissions. Mass and speciated hydrocarbon emissions were acquired for a fleet of ten 1989 model year vehicles operating on twenty-six fuels of differing heavy hydrocarbon composition. These fuels formed two statistically designed matrices: one examining the effects of medium, heavy, and tail reformate and medium and heavy catalytically cracked components; and the other examining the effects of heavy paraffinic versus heavy aromatic components and the effects of the 50% distillation temperature. In this paper the fates of fuel species were traced across the engine and across the catalyst, and correlations were developed between engine-out and tailpipe hydrocarbon species emissions and fuel composition.

Modal analyses have been performed on engine-out and tailpipe hydrocarbon and carbon monoxide mass emissions to help understand why fuels with increasing amounts of heavy hydrocarbon constituents produce significantly higher tailpipe hydrocarbon emissions, yet do not produce significantly higher tailpipe carbon monoxide emissions. Mass emissions were acquired for a fleet of ten 1989 model year vehicles operating on twenty six fuels of differing heavy hydrocarbon composition. These fuels formed two statistically designed matrices: one examining the effects of medium, heavy, and tail reformate and medium and heavy catalytically cracked components; and the other examining the effects of heavy paraffinic versus heavy aromatic components and the effects of the 50% distillation temperature.

Emission effects of gasoline hydrocarbon components distilling above 300°F were investigated to determine whether the effect of 90% distillation temperature (T90) found in an earlier Auto/Oil Program study is due to fuel distillation properties or to hydrocarbon composition, and also to determine whether the T90 effect is linear. Twenty-six fuels were tested in two sets. In Matrix A, the independent variables were catalytically cracked (FCC) and reformate stocks with nominal distillation ranges of 300 to 350, 350 to 400 and 400+°F. In Matrix B, the independent variables were a reformate stock (320 to 370°F), a heavy alkylate (330 to 475°F), and a light alkylate distilling below 300°F, which was used to vary fuel T50 at fixed levels of T90. Exhaust mass and speciation were measured using ten 1989 vehicles of the Auto/Oil Current Fleet. Tailpipe hydrocarbon emissions were found to increase nonlinearly with progressive addition of the heavier components.

Fuel economy measurements from portions of Phase I of the Auto/Oil Air Quality Improvement Research Program were analyzed. The following fuel variables were examined: aromatics, olefins, T90, RVP, and various oxygenates (MTBE, ETBE and ethanol). Two vehicle fleets were tested: twenty 1989 vehicles and fourteen 1983-1985 vehicles. Three measures of fuel economy were analyzed. EPA Fuel Economy used the calculation defined in the Federal Register and is an attempt to correct for changes in fuel properties. Volumetric Fuel Economy is based on a carbon balance calculation and is a measure of the actual volume of gasoline burned. Energy Specific Fuel Economy is a measure of fuel economy based on energy content. The following fuel changes resulted in reductions of Volumetric Fuel Economy in both fleets: reduced aromatics, reduced olefins, reduced T90, and addition of oxygenates. Changes in RVP did not have a significant effect on fuel economy.

Fuel effects on exhaust emissions of a sample of seven high emitting vehicles were studied. The vehicles had various mechanical problems and all ran fuel rich. The degree of enrichment varied between tests, and strongly affected mass emissions. Variable enrichment can cause incorrect apparent fuel effects to be calculated if not accounted for in data analysis. After variable enrichment was compensated for, the percentage effects of fuel oxygen, RVP, and olefins were largely in agreement with prior findings for normally emitting vehicles. Reducing fuel sulfur and T90 may have less benefit on hydrocarbon emissions in these high emitters than in normal emitters, and reducing sulfur may have less benefit on CO emissions. Reducing aromatics may be somewhat more helpful in reducing hydrocarbon and CO emissions in the high emitters.

Speciated exhaust emission data from Phase I of the Auto/Oil Air Quality Improvement Research Program are presented and analyzed. Eighteen fuels were tested which varied in four fuel parameters: aromatics, MTBE content, olefins, and T90. These fuels were tested in two fleets of vehicles. One consisted of twenty 1989 vehicles and the other consisted of fourteen 1983-1985 vehicles. The 1990 version of Carter reactivity factors were used to calculate reactivities for each of these tests. Two types of reactivities were calculated. The first was Specific Reactivity and has units of grams ozone per gram NMOG (non-methane organic gas). The second was Ozone Forming Potential and has units of grams ozone per mile. Both types of reactivities were calculated using Carter's MIR (Maximum Incremental Reactivity) as well as MOR (Maximum Ozone Reactivity) factors.

This report presents the Auto/Oil AQIRP results of a methanol fueled vehicle emission study. Nineteen early prototype flexible/variable fueled vehicles (FFV/VFV) were emission tested with industry average gasoline (M0), an 85% methanol-gasoline blend (M85), and a splash-blend of M85 with M0 (gasoline) giving 10% methanol (M10). Vehicle emissions were analyzed for the FTP exhaust emissions, SHED diurnal and hot soak evaporative emissions, and running loss evaporative emissions. Measurements were made for HC, CO and NOx emissions and up to 151 organic emission species, including air toxic components. M0 and M10 emissions were very similar except for elevated M10 evaporative emissions resulting from the high M10 fuel vapor pressure. M85 showed lower exhaust emissions than M0 for NMHC (non-methane hydrocarbon), OMHCE (organic material hydrocarbon equivalent), CO and most species. M85 had higher exhaust emissions for NMOG (non-methane organic gases), NOx, methanol and formaldehyde.

Exhaust and evaporative emissions were measured as a function of gasoline composition and fuel vapor pressure in a fleet of 20 1989 vehicles. Eleven fuels were evaluated; four hydrocarbon only, four splash blended ethanol fuels (10 vol %), two methyl tertiary-butyl ether (MTBE) blends (15 vol %) and one ethyl tertiary-butyl ether (ETBE) blend (17 vol %). Reid vapor pressures were between 7.8 and 9.6 psi. Exhaust emission results indicated that a reduction in fuel Reid vapor pressure of one psi reduced exhaust HC and CO. Adding oxygenates reduced exhaust HC and CO but increased NOx. Results of evaporative emissions tests on nineteen vehicles indicated a reduction in diurnal emissions with reduced Reid vapor pressure in the non-oxygenated and ethanol blended fuels. However, no reduction in diurnal emissions with the MTBE fuel due to Reid vapor pressure reduction was observed. Reducing Reid vapor pressure had no statistically significant effect on hot soak emissions.

Prior studies of the effect of gasoline composition and physical properties on automotive exhaust and evaporative emissions have been reviewed. The prior work shows that the parameters selected for investigation in the Auto/Oil Air Quality Improvement Research Program (AQIRP) - gasoline aromatics content, addition of oxygenated compounds, olefins content, 90% distillation temperature, Reid vapor pressure, and sulfur content - can affect emissions. Effects have been observed on the mass of hydrocarbon, CO, and NOx emissions; on the reactivity of emissions toward ozone formation; and on the emissions of designated toxic air pollutants. The individual effects of some of the AQIRP parameters have been studied extensively in modern vehicles, but the most comprehensive studies of gasoline composition were conducted in early 1970 vehicles, and comparing the various studies shows that fuel effects can vary among vehicles with different control technology.

An overview of Phase 1 of the Auto/Oil Air Quality Improvement Research Program is presented. Specific information is provided on each of the individual test fuel matrices that were conducted to investigate vehiclelfuel “system” effects on emissions. Procedures for sampling exhaust, evaporative, and running loss vehicle emissions are described, as well as techniques developed for speciation of individual hydrocarbons. Air quality models to project ozone reduction potential of reformulated gasolines and methanol, and economic studies to estimate the relative cost-effectiveness of the vehiclelfuel alternatives are also briefly explained.