Search Results

The rapid advancement of new energy vehicle technology has led to the widespread placement of battery packs at the bottom of vehicles. However, there is a lack of corresponding regulations and standards to guide aspects related to vehicle bottom safety. This lack of guidance obscures the relative importance of various parameters impacting the structural safety of battery packs under dynamic impact conditions. Consequently, research on battery pack bottom collisions holds practical significance and offers valuable reference material. This study proposed a method based on the first collision point to examine the impact of bottom collisions on the mechanical safety performance of battery pack bottoms. A finite element model of the battery pack was established to investigate the effects of different impact types.

The automotive active infrared detection system is usually applied to the night driver assistance system or the diver attention monitoring system. However, the infrared light emitted by the active infrared detection system can cause damage to retina, cornea and eye crystals. This paper has studied the photobiological safety of the infrared light source used in the automotive active infrared detection system. Although it has been already have the general requirements of photobiological safety in international standards, there is not any requirements for automotive active infrared detection system. The range of the active infrared detection system depends on the radiation intensity of the infrared light source, but too much radiation intensity will cause harm to retina, cornea and eye lens when the infrared light source is too close to eyes.

With the increasing frequency of fire incidents of electric vehicles, the safety of power batteries has attracted more and more attention. At present, the research on the safety of power batteries is mainly focused on fresh batteries. As the state of health of batteries deepens, how the safety of the battery evolves is not clear enough so far. This paper analyzes the external short-circuit safety of a NCM/C rectangular battery under different state of charges. The results show that when the cycle number is less than 800, the maximum temperature of the battery during short-circuit is below 130 °C. The main failure mode of the battery is bulging in volume or opening of the explosion-proof valve and there is no obvious regularity between the failure mode with the cycle life. However, when the cycle number reaches 1000, the battery goes into thermal runaway during the safety test.

Taking the pedestrian-vehicle accidents in the China in-Depth Accident Study (CIDAS) database as a sample case, 13 accidents morphological parameters were selected from three aspects: human, vehicle and environmental factors, and their depth analysis was carried out to obtain their distribution law through the card. The chi-square test and logistic regression method are used to analyze the correlation between the injury severity of pedestrians and other accidental morphological parameters in pedestrian-vehicle accidents. The results show that there is no significant correlation between gender/season and injury severity of pedestrians. The age of pedestrians and the collision speed is the strongest correlation with injury severity of pedestrians.

The fatigue load spectrum of the physical proving ground is the necessary input for fatigue life analysis of vehicle parts and components. It is usually obtained by Road Load Data Acquisition (RLDA) and loads decomposition using multi-body dynamics tools. Virtual Proving Ground (VPG) methodology is gradually replacing this technical strategy. The belgian road is the typical event in durability test, in this paper, the flexible body and FTire model are applied to the vehicle multi-body dynamics model in order to improve the simulation accuracy. The result shows that all the wheel center force, shock absorber displacement and axial force acquired by VPG simulation have excellent correlation with real vehicle measured data. It is also proved that the virtual proving ground technology is a reliable and effective method to obtain the fatigue load spectrum in the early stage of development.

With the development of vehicle technologies, vehicle safety is much better than before, many companies put research focus on harder accident scenarios. The 25% overlapping collision is considered as one type of most dangerous collision, this paper study this type accidents base on CIDAS database. Paper showed 7 scenarios appeared frequency in China, 11, 12, 1 o’clock are main impact direction. High way and freeway are the main places, and the head, thorax and lower extremities were the main sites of injury.

T-BOX can manage the vehicle’s operation data and position data, and provide the following functions, positioning, vehicle status, motor data, BMS working status, charging status and status alarm, which may effectively promote the development of electric vehicle. Meanwhile, it may bring a series of problems, especially the electromagnetic compatibility (EMC) problems. In this paper, for the exceed standard limits problem of a particular T-BOX sample in radiation emission (RE) and conducted emissions(CE) test process, π filter is designed and added to the positive polar and negative polar of power supply based on the analysis of hardware circuit. The conduction emission test results of T-BOX after optimized can meet the requirements of GB/T 18655-2010 Vehicles, boats and internal combustion engines-Radio disturbance characteristics-Limits and methods of measurement for the protection of on-board receiver standard.

Lower extremities are easily injured in traffic accidents. During pedestrian-vehicle crashes, pedestrian lower extremities are subjected to the influence of combined shear force and bending force, which could bring about ligament tear and bone fracture. According to 2018 China New Car Assessment Program (C-NCAP) pedestrian testing protocol, where the flexible pedestrian legform impactor (FLEX-PLI) is struck from the right lateral by vehicle, the injuries of the ipsilateral side leg are taken into account for assessing the performance of lower extremities. However, the contralateral leg injuries and deformation are neglected in the current testing protocol and the pedestrian walking gaits and the e-bike riding scenario have been little consideration. The purpose of this study is to investigate the injury characteristics of the contralateral lower extremities in pedestrian-vehicle and bicyclist-vehicle crashes.

The two-wheeler is a vehicle that runs on two wheels, which is classified as motorcycle, electric-bicycle, and bicycle in this research. China has the largest number of two-wheelers and relevant accidents in the world. The two-wheeler riders have a high level of vulnerability, creating a significant necessity to better understand the characteristics according to the road-user group. The objective of this paper is to study the characteristics and analyze the causes of two-wheeler accidents in China using the CIDAS (China In-Depth Accident Study) Database. 2012 cases of two-wheeler accidents with riders injured or dead were collected from the CIDAS Database from 5 cities (Changchun, Beijing, Weihai, Ningbo and Foshan) in China over a period of 5 years (2011.07-2016.06).

In China, nearly 25% of traffic fatalities are pedestrians. To avoid those fatalities in the future, rapid development of countermeasures within both passive and active safety is under way, one of which is autonomous braking to avoid pedestrian crashes. The objective of this work was to describe typical accident scenarios for pedestrian accidents in China. In-depth accident analysis was conducted to support development of test procedures for assessing Autonomous Emergency Braking (AEB) systems. Beyond that, this study also aims for estimating the mitigation of potential crash severity by AEB systems. The China In-depth Accident Study (CIDAS) database was searched from 2011 to 2014 for pedestrian accidents. A total of 358 pedestrian accidents were collected from the on-site in-depth investigation in the first phase of CIDAS project (2011-2014).

The aim of the study was to investigate the difference between car-to-e-bikes and car-to-pedestrian accidents. The China In-depth Accident Study (CIDAS) database was searched from 2011 to 2013 for pedestrians and e-bikes struck by car, van and SUV fronts, which resulted in 104 pedestrian and 85 e-bike cases where information was sufficient for in-depth analysis. Reconstruction by PC-Crash was performed for all of the sampled cases. Pre-crash parameters were calculated by a MATLAB code. Focus was on prototypical accident scenarios and causes; speed as well as possible prevention countermeasures. It has been shown that traffic light violations, road priority violations, and unsure safety (these situations included misjudgments, unpreparedness, proximity to other road users, inappropriate speeds, etc.…) are the main causes in both the VRU groups. Distinctions were found for aspects of car collision speed, accident scenario, distribution of head contact points and so on.