Search Results

The development of the S-designed metallic catalytic converter and the flexibility of its production paved the way for the first conical converter with continuous cell enlargement. This type of conical converter, installed upstream from a standard catalytic conversion system exerts a positive influence on flow distribution and converter efficiency, both during the cold start and under operating conditions. The study results outlined in the following text demonstrate the potential for increased catalytic effectiveness, taking the example of the close-coupled application.

The influence of physical parameters of the catalyst's substrate such as thermal mass, hydraulic diameter and geometric surface area on catalyst's efficiency is well known as published in numerous works. This paper will show interactions of these parameters and will provide a guideline on how to design the optimum system for a specific application, taking into account system's back pressure and system costs. Based on engine test bench results that show the influence of the physical parameters, the results for the optimized design regarding emission tests and maximum conversion rate at higher loads will be demonstrated.

Future catalyst systems need to be highly efficient in a limited packaging space. This normally leads to a design where the flow distribution, in front of the catalyst, is not perfectly uniform. Measurements on the flow test bench show that the implementation of perforated foils for the corrugated and flat foils has the capability to distribute the flow within the channels in the radial direction so that the maximum of the given catalyst surface is of use, even under very poor uniformity indices. Therefore a remarkable reduction in back pressure is measured. Emission results demonstrate cold start improvement due to reduced heat capacity. The use of LS - structured ( Longitudinal structured ) corrugated foils creates a high turbulence level within the single channels. The substrate lights-up earlier and the maximum conversion efficiency is reached more quickly.

1 An experimental study has been carried out on a production vehicle by means of roller-bench emission tests in order to optimize alternative aftertreatment systems. To this aim different comparisons between the production exhaust system and new strategies are discussed in the present paper with aid of both modal emission data and bag tailpipe figures. The present work shows the application of a alternative solution that complies with future emission legislation with regard both to HC, CO, NOx and PM without any major engine power output or fuel consumption penalty.

It has been shown within the catalyst industry that the emission performance with higher cell density technology and therefore with higher specific geometric area is improved. The focus of this study was to compare the overall performance of high cell density catalysts, up to 1600cpsi, using a MY 2001 production vehicle with a 4.7ltr.V8 engine. The substrates were configured to be on the edge of the design capability. The goal was to develop cost optimized systems with similar emission and back pressure performance, which meet physical and production requirements. This paper will present the results of a preliminary computer simulation study and the final emission testing of a production vehicle. For the pre-evaluation a numerical simulation model was used to compare the light-off performance of different substrate designs in the cold start portion of the FTP test cycle.

The effects of the internal geometry of catalytic converter channels on flow characteristics; exhaust backpressure and overall conversion efficiency have been investigated by means of both numerical simulations and experimental investigations. The numerical work has been carried out by means of a micro scale numerical tool specifically tailored for flow characteristics within converter channels. The results are discussed with aid of flow distribution patterns within the single cell and backpressure figures along the catalyst channel. The results of the numerical investigation provide information about the most efficient channel shapes. An experimental validation of the simulated results has been carried out with a production 3.6 liter, 6-cylinder engine on a dynamic test bench. Both modal and bag emission data have been measured during the FTP-Cycle.

Exhaust after-treatment systems will have to become increasingly efficient in order to comply with the strict emission limits that will apply in the European Union and worldwide in future. Moreover, space constraints, weight and low pressure drop are just some of the issues that have to be addressed by an EU III-compliant catalytic system. The development of metallic substrates over the past few years has shown that turbulent-like substrates increase specific catalytic efficiency. This has made it possible to enhance overall performance for a specific catalytic volume or reduce the volume while keeping catalytic efficiency constant. This paper focuses on the emission efficiency of standard, TS and PE metallic substrates. A simulation tool and flow bench measurements were used to develop a test matrix with catalyst similar pressure drop in order to examine different cell densities, substrate lengths and coating technologies.