Search Results

The growing necessity for less carbon emission vehicles due to environmental issues and more rigid legislation rules encourages many automotive companies to develop low CO2 emission engines. This motivation leads Mercedes-Benz do Brazil to the development of a “dual-fuel” diesel engine for buses that works with diesel and CNG (Compressed Natural Gas) fuel. One of the challenges for the development of this kind of engine is the electric/electronic integration between the diesel engine ECU (Electronic Control Units) and the CNG system ECU that coordinates the engine gas injectors.

With the discovery of oil and gas in the pre-salt Santos and Campos basin, the supply of natural gas (NG) is expected to increase considerably, so the use of compressed natural gas (CNG) in city buses will be an important option for reducing the overall consumption of fossil diesel fuel and a reduction in operating costs in São Paulo and Rio de Janeiro Metropolitan Areas in Brazil. A vehicle with an engine that can run on pure diesel or diesel and CNG has advantage over a vehicle that works exclusively with CNG, because when there is no availability or the lack of CNG, the vehicle / engine operates with diesel only. Another benefit of this technology is the resale value in Brazil, because after the life cycle of use in theses two big cities, Urban Buses are sold country side to small cities where CNG is not available.

The study is carried out through numerical and experimental methods. The finite element method is used to simulate the support mechanical behavior via modal analysis, and for the evaluation of stress concentration regions through pressure and thermoelastic static analyses, and dynamic analysis. The fatigue life is calculated for the presented stresses. Stress, acceleration and temperature data were obtained through dynamic test. For material evaluation, chemical analysis, hardness and metallographic analysis were carried out. For thoroughness, a failed support fractography will be presented. The objective of this study is to correlate the data obtained by numerical method with experimental data, and as a result, the support failure mechanism was identified. A modified support is presented to avoid the failure for the determined loads. The support within the proposed modifications reduces the current maximum stress in 41% and improved the fatigue life in 4.99e5 cycles.

With focus on reducing the Green House Gases emissions, the use of biodiesel as an alternative fuel, in special for buses that runs on the Brazilian metropolitan areas has been even higher. Additionally, with the introduction of the new legislation for diesel engines in 2012, CONAMA PROCONVE P7, that in order to attempt to its requirements uses different kinds of exhaust gases after treatment systems, the necessity of knowing the behavior of those “P7 engines” operating with different biodiesel contents on blends with regular fossil fuel or even pure biodiesel has been an important issue to ensure the benefits of using such alternative fuel. On this evaluation, blends of 5%, 10%, 20%, 30%, 50%, 75% and 100% of biodiesel content in ANP65/2011 A_S50 Diesel Fuel (50ppm Sulfur content) was experimented in a Mercedes-Benz OM926LA E5 engine with SCR (Selective Catalyst Reaction) exhaust gases after treatment system.

This work reports the first stage in the experimental optimization of a medium duty truck, equipped with a new engine, with four cylinders and high power, concerning both the noise emission for the environment and the noise level in the passengers' compartment. In the first stage of this work, comparative measurements among the noise levels for vehicles in different configurations were made, in order to identify the most important sources in the vehicle's noise level, as well as to serve as indicative for project improvements. Each system configuration was analyzed separately, in order to obtain a comparative evaluation of the different vehicle configurations along the whole period of measurements.