Search Results

In response to design requirements for lower weight and higher output, the motorcycle engine cylinder block has evolved from a cast cylinder block to an aluminum alloy cylinder block whose bore walls are surface-treated for wear-resistance. Hard-chromium plating, nickel-compound plating, and the like are in wide use as the wear-resistance surface treatment method, but spray technology has recently been attracting attention because of less impact on the environment, superior initial running-in performance and good oil retention. We have been applying a unique spraying method called wire explosion spraying to those models with a special need for wear-resistance surface. In this report we describe our wire explosion spray technology. With the aim of improving the bond strength of the sprayed coat, we studied the effects of the collided particles' form on bond strength in the wire explosion spraying conditions.

In order to improve the fuel efficiency and the operating performance of motorcycles, there is a need to reduce their weight. Magnesium, which is the lightest of the various metals currently being used and has a high specific strength, has the potential to satisfy that need. We conducted a study to clarify the weldability and strength characteristics of, and the most suitable surface treatment for, extruded magnesium alloys and rolled magnesium alloys. Based on the stress analysis by the finite element method, we designed a magnesium swing arm and produced the prototype swing arm by pressing hot rolled AZ31 magnesium alloy plates and welding them. The prototype is about 10% lighter and has higher torsional rigidity than a conventional aluminum swing arm.

Several elements affect the structure of eutectic silicon in hypoeutectic aluminum alloys [1, 2, 3, 4]. Among them, calcium has been investigated to a lesser extent compared to the typically used sodium and strontium. In order to enhance the thermal fatigue strength of a small engine, the morphology of eutectic silicon in hypoeutectic aluminum-silicon alloys is controlled by the addition of calcium. In addition, the castability and mechanical properties are investigated. Hence, samples containing different amounts of calcium are prepared at different cooling rates during solidification. The results revealed that, with the increase in the calcium amount and the cooling rate, eutectic silicon exhibits a fine morphology in cross-sectional images. Particularly, with the addition of at least 62 mass ppm of calcium in a specific range of cooling rates, refined eutectic silicon is obtained.