Search Results

The effect that thermally and compositionally stratified flowfields have on the spatial progression of iso-octane-fueled homogeneous charge compression ignition (HCCI) combustion were directly observed using highspeed chemiluminescence imaging. The stratified in-cylinder conditions were produced by independently feeding the intake valves of a four-valve engine with thermally and compositionally different mixtures of air, vaporized fuel, and argon. Results obtained under homogeneous conditions, acquired for comparison to stratified operation, showed a small natural progression of the combustion from the intake side to the exhaust side of the engine, a presumed result of natural thermal stratification created from heat transfer between the in-cylinder gases and the cylinder walls. Large differences in the spatial progression of the HCCI combustion were observed under stratified operating conditions.

Homogeneous charge compression ignition (HCCI) engines have the potential for high fuel efficiency and low NOx emissions. The major disadvantage of HCCI remains the narrow operating range. One way to extend the operating range of HCCI combustion to lower load is to inject part of the total fuel mass into the hot gas during recompression. With even lower engine load, part of the fuel can also be injected late in the main compression and ignited by a spark. The propagating flame further compresses the remaining fuel-air mixture until auto-ignition occurs (spark-assisted HCCI). In this study we investigated the effect of fuel reforming and spark assist in a gasoline engine with direct fuel injection and negative valve overlap. We performed experiments with different injection quantities and varying injection timings during recompression.

A combination of engine experiments and modeling was used to investigate the effectiveness of adding di-tertiary butyl peroxide (DTBP) to gasoline to extend the light load limit in a homogeneous charge compression-ignition (HCCI) engine. The light load combustion stability limit at an engine speed of 1000 rev/min was reduced from a fueling rate of 9 mg/cycle with neat gasoline to 6.2 mg/cycle with 15% DTBP addition. A companion modeling study was performed using a three-zone, zero-dimensional engine model combined with detailed chemical kinetics. The fuel used in the model was composed of 85% iso-octane and 15% n-heptane. The model yielded trends which were similar to the experimental results. In particular, a linear relationship was found between the experimentally measured minimum fueling rate and the calculated location of maximum energy release rate for various levels of DTBP addition.

Homogeneous charge compression ignition offers the potential for significantly lower NOx emissions and up to a 20% improvement in fuel economy relative to a conventional port fuel injected spark ignition (SI) engine. The most significant challenge to developing a production viable HCCI engine is controlling the phasing of autoignition and the combustion rate across the speed and load range of the engine. This report describes an experimental and computational evaluation of controlling HCCI combustion at low loads by adding partial oxidation gas (POx), CO and H2, to the intake manifold. Experiments were performed using charge dilution obtained through conventional exhaust gas recirculation and by modified valve timings to increase the internal residuals. The experimental results showed that POx gas inhibited the low temperature energy release from n-heptane, but promoted the autoignition of isooctane.

The objective of this work was to understand the physics of combustion-generated pressure waves from Homogeneous Charge Compression Ignition combustion and the resulting audible noise that is produced. Experiments were performed with a single-cylinder engine operating in both SI and HCCI combustion modes, and comparisons were made between the pressure waves generation from the two types of combustion. Cylinder pressure oscillation amplitudes at the first circumferential mode frequency (5 to 6 kHz) generated in HCCI combustion are 5 to 10 times higher than those generated in SI knocking combustion without an undue increase in audible engine noise. Frequency analysis of the data showed that in knocking combustion a larger portion of the wave energy is contained within the higher order resonance modes. Cylinder block vibration measurements indicate that the cylinder liner significantly dissipates the wave energy below 8 kHz.